User manual ADCOM GFB-800

[. . . ] Before using your washing machine, you must remove the shipping bolts from the back of the unit. For more information on removing the safety devices, refer to the user manual. Unscrew the emergency drain cap and pull out the emergency drain tube to drain off the remaining water. [. . . ] Make sure that the leveling feet legs are level with the floor. Clean the debris filter and the inside of the drain hose. Hold the cap on the end of the emergency drain tube and allow all the water to flow into a bowl. Replace the debris filter, the emergency drain cap and tube and then close the filter cover. Level your washer by turning the adjustable nut in and out, as shown in the figure. When your washing machine is level, tighten the locking nut using the (-) driver. If you open the debris filter when water remains inside the tub, water may flow out. If the debris filter is assembled incorrectly or not installed, it may cause a water leakage or operating error. Adding laundry Press the Add laundry(Stop&Add) button and add the laundry when the Add laundry lamp turns on. indication Symptom When the door is opened Action Is the door opened?Make sure to operate your washing machine after closing the door. If you insert more than the maximum drying capacity specified in the user manual, the drying performance may decrease. When the water does not drain Is the washing machine frozen because of the cold weather?Add hot water into the tub and let it defrost for about one hour. If fabric softener is inserted above the reference line (MAX) of the fabric softener compartment, fabric softener may enter directly into the tub. â· Insert fabric softener only up to the reference line (MAX) so that it does not overflow. If the rinse cap (hereafter cap) is not inserted correctly or there is foreign material in the cap when using concentrated fabric softener (liquid fabric softener of a high viscosity), fabric softener or water may remain. â· Check whether the cap is correctly inserted into the detergent compartment where the fabric softener is inserted. [. . . ] â· Check whether the cap is correctly inserted into the detergent compartment where the fabric softener is inserted. Did the washing machine pause while drying or performing an air wash?Only the Power and Start/Pause buttons operate while the `Hot' indication displays. [. . . ]