User manual ADCOM GTP-760

[. . . ] It is particularly important that you connect your preamplifier to your amplifier while the amplifier and preamplifier are unplugged and your other equipment is turned off. This will protect your equipment from potential short circuits that may occur during installion. In addition, it is important that you allow for adequate ventilation around your preamplifier and other equipment, since excessive heat buildup can shorten the life of any electronic product, including the preamplifier. Once you have correctly connected your new preamplifier to your other components, you should be able to enjoy many trouble-free years of performance. [. . . ] The ADCOM remote's status LED should flash green twice and then go back to steady orange. Release the button on the source remote. Repeat steps 3 through 5 for any other commands you want to teach your ADCOM remote for that source component. Save the commands you've just programmed into the ADCOM remote by pressing and holding the appropriate source selector and select buttons simultaneously. Hold until the status LED and source selector LED flash twice and then go out. Repeat these steps for any other source commands you wish to program. Using Pre Programmed Commands Using the remote controller's pre programmed commands is simple. For most GTP-760 functions (volume up/down, changing surround modes, etc. ), follow these easy steps. This tells the remote that you want to use GTP-760 pre programmed commands. The main button will flash red to tell you it understands. Press the appropriate function button (volume up, volume down, etc. ) If you've selected a button that actually triggers a GTP-760 command, the main button will again flash red to confirm your choice. If the main button does not flash, you've selected a function button that isn't pre programmed. Press either the group 1 or group 2 source selector button (main or vid 1 respectively) and the mute button simultaneously. Hold both buttons until the red status LED and the input selector button remain lighted. Press the macro initiator button (m1, m2, m3 or m4) you wish to program. Select and press up to ten buttons you wish to store in the macro. Both source selector and function buttons count as individual commands. Remember that each macro can hold only up to ten individual commands. Press the random button to save the macro. The red status LED and input selector button will blink twice to confirm programming and then turn off. · To add a power (on/off) command to the macro, use the mute button in place of the power button. · The random/tone buttons cannot be used in a macro sequence. Press either the group 1 or group 2 source selector button (main or vid 1 respectively) and the mute button simultaneously. [. . . ] 20 Hz to 15 kHz ± 1dB AM Tuner Section Sensitivity (20dB S/N) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 400uV S/N . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 50dB Distortion . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 0. 7% One Signal Selectivity (± 10kHz) . . . . . . . . . . . . . . . . . . . . . [. . . ]