User manual ADCOM GTP-880

[. . . ] ADCOM GTP-880 Owner's Manual | 1 WELCOME Dear fellow ADCOM product owner, Welcome to the ADCOM family!For more than twenty years, ADCOM products have delivered excellent performance and value for customers around the world. Our products are designed by our experienced and demanding engineering team, built to the highest standards in our factory, and sold and serviced through dealers, custom installers, and other retailers whose primary goal is your complete satisfaction. We know you are anxious to hear your new preamplifier in action, but please take a few minutes to read this owner's manual before connecting the preamplifier to your system. [. . . ] For tuner functions (changing stations, etc. ): 1. Press the tuning up (or tuning down) function button to change stations. The tuner source selector will flash red to confirm that the function button you've selected actually triggers a command. (Again, use the table to see which buttons are pre programmed. ) Press the CD source selector first to access pre programmed commands for ADCOM CD players. Note: You can program new commands over the pre programmed commands in tuner and CD if you wish. However, you cannot program any buttons, even those unprogrammed with GTP-880 command codes, while you're in main mode. This safety feature assures you that you will always be able to fully enjoy the GTP-880's capabilities. Programming Your Own Commands You can supplement pre programmed commands with commands to operate other components. Before you begin to follow these steps, note the status LED located at the top left corner just above the remote's button panel: It will flash red, orange, or green to signal particular functions as you enter new commands into your ADCOM remote. Begin by deciding which source component's commands you will be transferring to the ADCOM remote. Then press Deleting Individual Commands 1. Press the ADCOM remote's source selector and select buttons simultaneously and hold until the orange status LED and the source selector button glow steadily. Press the function button you wish to clear. The status LED will flash continuously. 32 | ADCOM GTP-880 Owner's Manual 3. The status LED will then flash green twice and then revert to steady orange. The source selector button will continue to glow. Repeat steps 2 and 3 for any other command you wish to delete for the same source component. Exit "delete mode" by pressing and holding the source selector and select buttons simultaneously. The orange status LED and the source selector button will turn off. store and transmit either of two complete macros, depending on which source selector is active when you push it. For macro programming purposes, think of the source selectors as being in two groups: main, DVD, VCR, and CD in group 1; vid 1, vid 2, vid 3, and tuner in group 2. When you program a "group 1" macro, you will start by pushing the main source selector. After you've completed and memorized that macro command series, you can initiate it whenever you're in main, DVD, VCR or CD modes. Similarly, you will program "group 2" macros by pushing vid 1 first and can use them whenever the video 1, video 2, video 3, or tuner inputs are active. [. . . ] 24 dB/octave (4th order), 40-150Hz as above Tone Control Bass Center Frequency/Range . 100Hz / ± 8dB Treble Center Frequency/Range . 10kHz / ± 8db Channel Separation (at 1kHz) . 80dB Crosstalk Between Inputs (at 1kHz) . [. . . ]