User manual ADCOM REMOTE SENSOR XR-500II

[. . . ] Elegant design with digital touch sensors Digital touch sensors are used in the control panel for more simple operation, with a touch of elegance. 3. Quadruple filter system The quadruple filter system and the food filtration device crushes food remains from the dishes, glasses, cooking pots and cutlery inside the dishwasher into small particles. Since food remains are crushed by stainless blades, then filtrated, collected and picked out by the draining cycle, you do not need to worry about any food remains inside bowls and dishes. Your Samsung dishwasher has the best filtration performance of dishwashers in its class. [. . . ] Turn on the water supply. Drain hose 1. If you use only the drain hose for drainage, place and install it below 80 cm from the ground. If the drain hose is installed higher than 80 cm, dirty water may flow back or a significant amount of dirty water may remain inside the dishwasher. below 80 cm WARNING 2. If you are sharing one drain pipe for the draining both the dishwasher and the sink, connect the drain hose of the dishwasher to the Y-adapter as shown in the figure below. Do not install the Y-adapter higher than 80 cm from the ground. This may result in dirty water flowing back or a significant amount of dirty water remaining inside the dishwasher. y-adapter saddle clamp below 80 cm WARNING setting up your dishwasher _11 UserManual-DMS400TH_EN-Australia. indd 11 2010-07-01 6:16:57 setting up your dishwasher ConTroL PAnEL 1 5 2 1 pOWeR When pressed, all indicator lights turn on and off and the most recently finished program light is lit. When the dishwasher is running and a selected program has finished, `En' is displayed and the power turns off automatically. You can select the appropriate wash program depending on the soil level of your dishes. When a program is selected, the indicator for that program lights up. Displays the remaining wash time, the wash information (Delay start, Rinse refill, Child lock), and error messages. If an error occurs during an operation, an error message is displayed with a warning sound. - For the Quick program, the "Additional Dry" option is not available so the total processing time will remain unchanged. - For the Prewash program, the PLUS option will be disabled. setting up your dishwasher _13 UserManual-DMS400TH_EN-Australia. indd 13 2010-07-01 6:16:58 setting up your dishwasher ProGrAm sELECTor 1 2 3 4 5 6 1 dAIly QUICK pOTS & pANS CRySTAl NORmAl pReWASh Use this program for highly soiled dinner dishes. Use this program for lightly soiled dishes. Detergent is dispensed but no dry cycle is initiated. Use this program for hard-to-clean, heavily soiled dishes, pots and pans, and dishes with heavy oil. Use this program for normally soiled dishes or fragile items such as glasses. Use this program for normaly soiled crockery. To improve the cleaning efficiency, keep dishes soaked in water before washing the dishes. 2 3 4 5 6 DIsPLAy Child lock Washing drying delay Start Rinse Refill Rinsing 1. When Delay Start or Child Lock are selected, the respective indicators are lit. When "Rinse Refill" remains lit, there is no rinse aid in the dispenser and you should refill the rinse aid dispenser. If the door is opened while a cycle is in progress, the remaining time will flash. 14_ setting up your dishwasher UserManual-DMS400TH_EN-Australia. indd 14 2010-07-01 6:16:58 using your dishwasher ADjusTInG ThE AnGLE of ThE PLATE suPPorTs The foldable plate spikes in the top and bottom baskets allow you to adjust the angle of the tines up to five different levels according to the size and shape of the dishes. [. . . ] Sound is generated when the drain pump is operating at an early stage. The dishwasher is not level. Ensure that the dishwasher is level. There is a `chopping' sound because Rearrange the dishes. Leaves black or gray marks on the dishes. The supplied water is soft and too much detergent is being supplied. [. . . ]