User manual ADDONICS HDUS3325DX

[. . . ] ADDONICS TECHNOLOGIES Model: HDUS3325DX Make sure that the capacity of the target hard disk is equal or larger than the source hard disk. For example, on the label of the hard drives, it might identify both drives as 80GB but the actual size differs. [. . . ] 2 ­ it is used to scroll up function menus. 3 ­ it is used to scroll down function menus. 4 ­ it is used to execute a function. 5 ­ it is used to cancel a function. IV. Duplicating a drive When the duplicator powers on, it initializes and goes through the steps below Duplicator Panel Shows the firmware version Source Drive Bay Target Drive Bay1 Target Drive Bay2 Target Drive Bay3 Power Switch Initialize SDRAM's status. . Detect Drives' status. Shows the first function: Step 1 Open the source drive door and slide in the 3. 5" SATA hard disk Source drive into the drive bay. Close the front panel and using the key provided, turn the key lock to the Lock position. This will secure the drive and turn on the power to the hard drive. Step 2 Open the target drive door(s) and slide in the 3. 5" SATA hard disk Target drive(s) into the drive bay. Close the front panel and using the key provided, turn the key lock to the Lock position. This will secure the drive and turn on the power to the hard drive. Copy HDD copies data directly from the source hard disk to the target hard disk. The system will auto-detect the hard disks and show the following info on the LCD. The LCD will show the following info during the copying process: remaining time, completed percentage. The copy speed, capacity and time will vary depending on the source hard disk. [. . . ] Push the auxiliary switch button to turn on the HDD duplicator. Technical Support Contact Information Phone: 408-573-8580 Fax: 408-573-8588 Email: http://www. addonics. com/sales/query/ Internet: http://www. addonics. com TECHNICAL SUPPORT Phone: 408-453-6212 Hours: 8:30 am - 6:00 pm PST Email: http://www. addonics. com/support/query/ c. [. . . ]