User manual ADDONICS HDUS35DX

[. . . ] ADDONICS TECHNOLOGIES Model: HDUS35DX I. Installing drive into the HDD Duplicator Note: Make sure that the capacity of the target hard disk is equal or larger than the source hard disk. [. . . ] Close the front panel and using the key provided, turn the key lock to the Lock position. This will secure the drive and turn on the power to the hard drive. Step 2 Open the target drive door and slide in the 3. 5" SATA hard disk Target drive into the drive bay. Close the front panel and using the key provided, turn the key lock to the Lock position. This will secure the drive and turn on the power to the hard drive. Copy HDD copies data directly from the source hard disk to the target hard disk. The system will auto-detect the hard disks and show the following info on the LCD. The LCD will show the following info during the copying process: remaining time, completed percentage. The copy speed, capacity and time will vary depending on the source hard disk. Once the copying process is complete the LCD will display the following results. Note: Refer to the Snap-In 25 user guide for 2. 5" SATA hard drive installation on the HSUS35DX. Connecting the power cable and powering on Connect the power cord provided from the wall outlet to the back of the HDD Duplicator. A power switch is located on the front of the tower. Push the button to turn on the HDD duplicator. The complete user manual of the HDD Duplicator can found in the Driver Disk under User Guides or can be downloaded from http://www. addonics. com/support/user_guides/ III. [. . . ] 4 ­ it is used to execute a function. 5 ­ it is used to cancel a function. Technical Support Contact Information Phone: 408-573-8580 Fax: 408-573-8588 Email: http://www. addonics. com/sales/query/ Internet: http://www. addonics. com TECHNICAL SUPPORT Phone: 408-453-6212 Hours: 8:30 am - 6:00 pm PST Email: http://www. addonics. com/support/query/ [. . . ]