Lastmanuals offers a socially driven service of sharing, storing and searching manuals related to use of hardware and software : user guide, owner's manual, quick start guide, technical datasheets... DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!
If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Lastmanuals provides you a fast and easy access to the user manual ADDONICS ZESSIU3CS. We hope that this ADDONICS ZESSIU3CS user guide will be useful to you.
Lastmanuals help download the user guide ADDONICS ZESSIU3CS.
Detailed instructions for use are in the User's Guide.
[. . . ] Enclosure Overview
Screw 1 Switch Screw 2
Addonics
TECHNOLOGIES
Fan eSATA Port Power Connector
Removing the front panel Z USB3. 0 / eSATA Combo Drive Enclosure for SATA or IDE Hard drive or Optical drive Model: ZESSIU3CS You can remove the front panel of the enclosure to access the drive drawer of the optical drive.
User's Guide
Step 1 Loosen the two screws from the rear panel. [. . . ] However, there is no guarantee that interference will not occur in a particular installation. If the equipment does cause harmful interf erence to radio or television reception, which can be determined by turning the equipment on and off, the user is encouraged to try and correct the interference by one or more of the following suggestions. Reorient or relocate the receiving antenna Increase the distance between the equipment and the receiver Connect the equipment to a different power outlet other than the one where receiver is connected Consult a certified television or radio technician
A.
Installing a 3. 5" SATA hard drive
SATA hard drive
TECHNICAL SUPPORT Phone: 408-453-6212 Hours: 8:30 am - 6:00 pm PST Email: http://www. addonics. com/support/query/
Slide in the 3. 5" SATA hard drive and secure on the tray using screws.
B.
Installing a 3. 5" IDE hard drive The Z USB3. 0 / eSATA combo drive enclosure comes with an IDE to SATA converter.
40-pin IDE Connector
4.
At the other end of the Y-power cable is the 4-pin floppy power connector which you connect to the converter. Now connect the SATA cable to the SATA port on the converter.
SATA Port
4-Pin Floppy Power 5. Note: It is required to set up the IDE hard drive you are connecting to the converter as a MASTER device. Locate the 40-pin IDE connector of your IDE drive. Disconnect the SATA board from the drive enclosure. Then connect the SATA cable to the SATA port on the IDE to SATA converter
SATA board
4-pin Molex Power Connector
ADSAIDE IDE to SATA converter
40-pin IDE Connector
Master or Slave Jumper Settings
2. [. . . ] Step 3 Use the enclosed screws to secure the hard drive to the tray.
Screw holes [. . . ]
DISCLAIMER TO DOWNLOAD THE USER GUIDE ADDONICS ZESSIU3CS
Lastmanuals offers a socially driven service of sharing, storing and searching manuals related to use of hardware and software : user guide, owner's manual, quick start guide, technical datasheets... In any way can't Lastmanuals be held responsible if the document you are looking for is not available, incomplete, in a different language than yours, or if the model or language do not match the description. Lastmanuals, for instance, does not offer a translation service.
Click on "Download the user manual" at the end of this Contract if you accept its terms, the downloading of the manual ADDONICS ZESSIU3CS will begin.
