User manual ADI COMMUNICATIONS AR-446

[. . . ] 49 General problems with the dishwasher . 64 Cleaning the drain pump and non-return valve . 71 3 IMPORTANT SAFETY INSTRUCTIONS WARNING ­ When using your dishwasher, follow basic precautions, including the following: Read all instructions before installation or use of the dishwasher to prevent injury and machine damage. Electrical Safety Before installation, make sure that the voltage and frequency listed on the data plate correspond with the household electrical supply. This data must correspond to prevent injury and machine damage. [. . . ] The display changes to the time of day setting. Set the time of day ^ Set the hour and confirm with OK. The display changes back to the previous menu. To switch back to "Settings J" - select Back. Detergent z To achieve best results the used detergent can be set on your dishwasher. The selections available are "Powder", "Gel", "2 in 1" and "3 in 1" tabs. The program cycle sequence will be adjusted for the selected detergent. Depending on the program the program running time could increase. Powder When using powder detergent, salt and rinse aid must be added for best results. See "Filling the salt container" and "Rinse aid" for more info. The rinse aid refill message is activated. Gel When using gel detergent, salt and rinse aid should be added for best results. The three most frequently used programs can be saved to the first three positions. C k Back A 1. Pots + Pans e ^ Select from the first three programs the one, which you would like removed from the top three. . ^ Confirm with OK. C j Starch Cheese Sani Wash e - Filter check h This selection allows you to set the number of cycles run before the filter check message shows. You can select between 30 and 60 cycles. The filter check message is set by default to 40 cycles. ^ Select the desired number of cycles and confirm with OK. See "Cleaning and Care - Triple filter system" for more information. ^ Select the program to be saved to the position of the previously selected program. The reorganizing is confirmed and the new order of programs is shown. C k Back A 1. Pots + Pans e Adjust Sensor Wash The "Sensor Wash" program can be adjusted to clean stubborn but normal soiling. ^ Select Yes and confirm with OK . ^ Reorganize another program or switch back to "Settings J" with Back. 42 Settings J Save options Ö Additional options can be selected for some programs, e. g. See "Use - Selecting options". Save options Child Safety Lock X The Child Safety Lock protects the dishwasher from misuse. [. . . ] If there is any question concerning the proper electrical connection or grounding of this appliance to the power supply, please consult a licensed electrician or call Miele's Technical Service Department: U 1-800-999-1360 V 1-800-565-6435 Specifications The dishwasher comes equipped with a 4 ft (1. 2 m) power cord with a molded plug for connection to 120 V, 60 Hz, 15 A grounded receptacle. 69 Plumbing Connection to the water supply ­ The water inlet hose comes equipped with a 3/4" female hose thread connector. This can be directly connected to a water supply with 3/4" MHT (male hose thread ends). ­ Water pressure: Must be between 4. 5 - 145 psi (0. 3 - 10 bar). If the water pressure is lower, the display shows Water intake see "Frequently asked questions". , Do not drink water from the dishwasher! [. . . ]