User manual ADS TECH PTV-360

[. . . ] Make sure you match the polarities to avoid damage to the Remote Control. 5 Stereo Link cable to the Audio Out connector on the back of the TV Station 100, the other end should be connected to the Line In of your PC's Sound Card. You can use a regular indoor antenna (TV reception may not be optimal depending on your location), roof antenna or a Coaxial cable if you have Cable service. Connect the power adapter to the DC connector on the back of the unit and then plug the power adapter to a working power outlet. [. . . ] Answer: No, the TV Station 100 does not require any software or driver installation to work. Just follow the instructions provided on how to connect to a LCD or CRT to get your TV signal. Answer: No, you will be switching between the Component (YPbPr) and the RCA/SVideo output, but not both at the same time. Question: I am not getting any Audio from the TV Station 100. Answer: If you are not using the TV Station 100 with a PC, you need to connect the Audio Out to a Powered PC Speakers. Answer: The Audio will stop working if you have connected the Audio Out of the TV Station 100 to the Line In of your PC Sound Card, since the PC has been switched off. Question: I adjusted the Video Options, but now the image does not look good. answer: Please select the Reset option on the Video Menu. This will reset the adjustments to factory settings. Question: I am getting a lot of channels with bad signal after the channel scan. Answer: You can use the ADD/DEL CH button on the Remote Control to clear any bad channels. Answer: Press the channel you want on the Remote Control keypad, wait 2 seconds for the TV Station 100 to switch to that channel or just press the Enter button on the Remote to switch to your selection. What are the different types of TV Systems available?If an outside antenna is connected to the equipment, be sure the antenna system is grounded so as to provide some protection against voltage surges and built-up static charges. Section 810 of the National Electrical Code provides information with respect to proper grounding of the mast and supporting structure, grounding of the lead-in wire to an antenna discharge unit, size of the groundving conductors, location of antenna-discharge unit, connections to grounding electrodes, and requirements for the grounding electrode. For added protection for this electronic equipment during a lighting storm, or when it is left unattended and unused for long period of time, unplug it from the wall outlet and disconnect the antenna. An outside antenna system should not be located in the vicinity of overhead power lines or other electric light or power circuits, or where it can fall into such power lines or circuits. When installing an outside antenna system, extreme care should be taken to keep from touching such power lines or circuits as contact with them might be fatal. If you require assistance with the installation, operation, or application of your ADS Technologies, Inc. Product there are several options available to you as described in the technical support section of this manual. The ADS Technologies technical support and customer service staff can aid in solving many problems. Our technical support department is available to repair any ADS Technologies product. [. . . ] These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a residential installation. This equipment generates, uses and can radiate radio frequency energy and if not installed and used in accordance with the instruction manual may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: * Reorient or relocate the receiving antenna. [. . . ]