User manual ADT ICENTER 8142ADT

[. . . ] L&HQWHU $GYDQFHG8VHU, QWHUIDFH $'7 8VHU*XLGH K5763-1 1/01 Table of Contents ABOUT ICENTER . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 9 Introduction to iCenter. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 9 The iCenter Interface . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 9 Navigating through iCenter . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] Press [1] for low, [2] for medium, or [3] for high volume. ENTER VOLUME: 1-LOW 2-MED 3-HI The system automatically returns to the Main Menu with the new volume setting in effect. 70 TeleSMART Messaging Features (Cont'd) Toll Saver / Message Beeps Using the TeleSMART Touchpad (Options 12 & 13) 09 Touchpad CID 10 Aux CID 11 Aux Volume 12 Toll Saver 13 Message Beeps 14 HF Touchpad 15 HF Aux 16 Handset On/Off NAVIGATION: [] = Next Option; [#] = Previous Option; [7] = GOTO prompt; [9] = Exit System. About the Toll Saver Feature The Toll Saver feature lets you call in to the system to check if there are new messages (determined by the number of rings). This lets you hang up before incurring toll charges. The Toll Saver feature works in combination with the security system. First, you must turn Toll Saver on (shown below), but it becomes active only when the security system is armed in the AWAY or MAXIMUM mode. The Toll Saver feature is inactive when the security system is disarmed or when armed STAY or INSTANT. When Toll Saver is active (option is on and system is armed AWAY or MAXIMUM), the "distinctive ring" feature is automatically disabled. How to Turn Toll Saver On/Off PROGRAM MODE 12 TOLL SAVE:ON Toll Saver: 1. Go to the "Toll Saver" prompt (option 012). To turn the Toll Saver feature on, press [0]. To turn Toll Saver off, press [0] again. How to Check for Messages while Toll Saver is On 1. Call in to the system and listen for the number of rings: 2 rings = There are new messages/memos in one or more of the mailboxes 4 rings = There are no new messages/memos in any of the mailboxes 2. To save toll charges if there are no new messages, hang up after the third ring. About Message Beeps The system can alert you to new messages whenever you pick up the telephone receiver, if desired. If the message beeps feature is turned on and you have new messages, the system beeps over the dial tone when you pick up the receiver. How to Turn Message Beeps On/Off PROGRAM MODE 13 MSG BEEP:ON Message Beeps 1. Go to the "Message Beeps" prompt. To turn Message Beeps off, press [0] again. 71 TeleSMART Messaging Features (cont'd) Call Screening Using the TeleSMART Touchpad (Options 14, 15, 16) 09 Touchpad CID 10 Aux CID 11 Aux Volume 12 Toll Saver 13 Message Beeps 14 HF Touchpad 15 HF Aux 16 Handset On/Off NAVIGATION: [] = Next Option; [#] = Previous Option; [7] = GOTO prompt; [9] = Exit System. About Call Screening Call Screening lets TeleSMART answer your calls while you listen in from any phone and/or touchpad or auxiliary speaker (depending on programming) without the caller hearing you. CALL SCREENING FROM. . . Telephone (handset) LETS YOU. . . listen to a caller's incoming message from the telephone without the caller hearing you. You can then connect to the call or let TeleSMART continue recording the caller's message. This is known as Handset Call Screening. hear a caller's incoming message at the touchpad and/or auxiliary speaker without the caller hearing you. You can then pick up a telephone receiver to connect to the call or let TeleSMART continue recording the caller's message. This is known as Hands Free (abbreviated "HF") call screening. Touchpad and/or Speaker How to Connect to a Call when Telephone Call Screening is On 1. As you hear the caller leaving a message, click the "off-hook" button once, in the same way you would when switching between callers if you had Call Waiting service. [. . . ] to 4:30P. M. , Monday through Friday, except holidays. Services rendered outside the normal working hours of ADT are not within the scope of this warranty and any services requested to be performed at such times shall be charged for at ADT's then applicable rates for labor and material. This warranty does not apply to the conditions listed below, and in the event customer calls ADT for service under the warranty and upon inspection it is found that one of these conditions has led to the inoperability or apparent inoperability of the system, a charge will be made for the service call of the ADT representative, whether or not he actually works on the system. Should it actually be necessary to make repairs to the system due to one of the "conditions Not Covered By Warranty", a charge will be made for such work at ADT's then applicable rates for labor and material. Conditions Not Covered By Warranty. A. Damage from accidents, acts of God, alterations, misuse, tampering or abuse. [. . . ]