User manual ADVANCE MAP-105

[. . . ] CAUTION: To prevent the risk of electric shock, do not remove cover (or back); no user serviceable parts inside. An appliance and cart combination should be moved with care. Before any transportation, your product must be packed correctly in order to avoid any damage. [. . . ] SERVICING The user should not attempt to service the appliance beyond that described in the operating instructions. All other servicing should be referred to qualified service personnel. POWER-CORD PROTECTION Power-supply cords should be routed so that they are not likely to be walked on or pinched by paying particular attention to cords at plugs, convenience receptacles, and the point where they exit from the appliance. CLEANING The appliance should be cleaned only as recommended by the manufacturer. POWER LINES An outdoor antenna should be located away from power lines. NON-USE PERIODS The power cord of the appliance should be unplugged from the outlet when left unused for a long period of time. OBJECT AND LIQUID ENTRY Care should be taken so that objects do not fall and liquids are not spilled into the enclosure through openings. STANDBY/ON POWER BUTTON Press this button to turn ON your appliance, power is supplied to your unit and it becomes operational, the STANDBY indicator blue lights after few seconds. (The main power switch is located on the back panel and must be ON in order to use STANDBY function). When set to STANDBY the main power is cut-off and the unit is no longer fully operational except for the micro controller. The standby indicator red lights during standby. Original owner's manual MAP105 29/11/06 12:57 Page 7 CD INPUT Press this button to select the CD as your listen source. The audio signal of CD is an analog RCA type connector. Also on this input, you have the possibility to use others sources with same audio signal output like tuner, tape, MD, etc. TUNER INPUT Press this button to select the tuner as your listen source. The audio signal of CD is an analog RCA type connector. Also on this input, you have the possibility to use others sources with same audio signal output like tuner, tape, MD, etc. BOUTON DE VOLUME VYour amplifier used a rotary type knob to control the 2 channel output sound level (left and right). [. . . ] SPEAKER TERMINALS Connect cables between speakers and your amplifier. PRE-OUT / MAIN IN / BRIDGE Without this bridge, you can used separetly the preamplifier or the power amplifier. POWER CORD /MASTER ON/OFF SWITCH / VOLTAGE SELECTOR Before plugging in the amplifier, its master power switch must be in the OFF position. [. . . ]