User manual ADVANCE MAP-308

[. . . ] WATER AND MOISTURE The appliance should not be used near water for example, near a bathtub, washbowl, kitchen sink, laundry tub, in a wet basement, or near a swimming pool, etc. VENTILATION The appliance should be situated so that its location or position does not interfere with its proper ventilation. For example, the appliance should not be situated on a bed. Sofa, rug, or similar surface that may block the ventilation openings; or, placed in a built-in installation, such as a bookcase or cabinet that may impede the flow of air through the ventilation openings. [. . . ] wARNING ATTENTION No good Good Your product is designed to be placed on a firm and level surface. Don’t place the unit sideways, a big power exerts on the single side of the plate. With this power, the plate will be broken easily. STATIC ELECTRICITY ELECTRICITÉ STATIQUE The window of the meters is antistatic treated, also, it’s very important to clean it with an antistatic approved liquid. Inputs Sélecteur d’entrées numériques (MAP-308 seulement) Digital inputs selector (MAP-308 only) Diminution du volume Decrease volume Fonction Stand-by Standby function Entrées Tuner et PC Tuner and PC inputs Entrée Phono Phono input Fonction silence Mute function Augmentation du volume Increase volume IMPORTANT To switch on the Power amps direct function, please push “Normal/Amp” button of the remote control during 3 seconds. To cancel this mode, please push on the “Normal/Amp” button of the remote during 3 seconds. STANDBY/ON POWER BUTTON Press this button to turn ON your appliance, power is supplied to your unit and it becomes operational, the STANDBY indicator blue lights after few seconds. (The main power switch is located on the back panel and must be ON in order to use STANDBY function). When set to STANDBY the main power is cut-off and the unit is no longer fully operational except for the micro controller. The standby indicator red lights during standby. L CD INPUT Press this button to select the CD as your listen source. The audio signal of CD is an analog RCA type connector. Also on this input, you have the possibility to use others sources with same audio signal output like tuner, tape, MD, etc. TUNER INPUT Press this button to select the tuner as your listen source. The audio signal of CD is an analog RCA type connector. Also on this input, you have the possibility to use others sources with same audio signal output like tuner, tape, MD, etc. VOLUME BUTTON Your amplifier used a rotary type knob to control the 2 channel output sound level (left and right). Turn this volume knob clockwise to increase the ouput sound level and turn this volume knob counterclockwise to decrease the output sound level. [. . . ] To com back to the original normal mode, push again this button during about 3 seconds. OPTICAL (1), COAXIAL (3) AND AES/EBU (1) DIGITAL INPUTS Your amplifier integrate a DAC (Digital audio converter) with 5 inputs, 3 are coaxials, 1 is optical and 1 is AES/EBU. You can connect the digital output of you CD, MD, etc. And use the high quality DAC converter of your amplifier. [. . . ]