User manual ADVANCE MAP-800II

[. . . ] VENTILATION DAMAGE REQUIRING SERVICE The appliance should be situated so that its location or position does not interfere with its proper ventilation. For example, the appliance should not be situated on a bed. Sofa, rug, or similar surface that may block the ventilation openings; or, placed in a built-in installation, such as a bookcase or cabinet that may impede the flow of air through the ventilation openings. HEAT The appliance should be situated away from heat sources such as radiators, heat registers, stoves, or other appliance (including amplifiers) that produce heat. [. . . ] Don’t place the unit sideways, a big power exerts on the single side of the plate. With this power, the plate will be broken easily. STANDBY/ON POWER BUTTON Press this button to turn ON your appliance, power is supplied to your unit and it becomes operational, the STANDBY indicator blue lights after few seconds. (The main power switch is located on the back panel and must be ON in order to use STANDBY function). When set to STANDBY the main power is cut-off and the unit is no longer fully operational except for the micro controller. The standby indicator red lights during standby. Original owner's manual MAP800II 24/07/09 10:31 Page 8 CD INPUT Press this button to select the CD as your listen source. The audio signal of CD is an analog RCA type connector. Also on this input, you have the possibility to use others sources with same audio signal output like tuner, tape, MD, etc. TUNER INPUT Press this button to select the tuner as your listen source. The audio signal of CD is an analog RCA type connector. Also on this input, you have the possibility to use others sources with same audio signal output like tuner, tape, MD, etc. BOUTON DE VOLUME Your amplifier used a rotary type knob to control the 2 channel output sound level (left and right). Turn this volume knob clockwise to increase the ouput sound level and turn this volume knob counterclockwise to decrease the output sound level. AUX INPUT 1 OR 2 Press this button to select the Aux. 1 is an analog RCA type connector or XLR for balanced inputs. Also on this input, you have the possibility to use others sources with same audio signal output like tuner, tape, MD, etc. Original owner's manual MAP800II 24/07/09 10:31 Page 9 PHONO INPUT Press this button to select the phono input as your listen source. [. . . ] This connection must be important in minimizing AC hum. POWER CORD /MASTER ON/OFF SWITCH / VOLTAGE SELECTOR Before plugging in the amplifier, its master power switch must be in the OFF position. Also, you need to be sure about the voltage of your country. In case that you need to use your appliance in 115V, you need to change the position of the voltage switch and to replace the voltage fuses by those included in your product. [. . . ]