User manual ADVANCE MAX-450

[. . . ] WATER AND MOISTURE The appliance should not be used near water for example, near a bathtub, washbowl, kitchen sink, laundry tub, in a wet basement, or near a swimming pool, etc. VENTILATION The appliance should be situated so that its location or position does not interfere with its proper ventilation. For example, the appliance should not be situated on a bed. Sofa, rug, or similar surface that may block the ventilation openings; or, placed in a built-in installation, such as a bookcase or cabinet that may impede the flow of air through the ventilation openings. [. . . ] HEADPHONE You can connect a stereo headphones to the phone jack for private listening. Notes: always turn down the volume before connecting your headphones. Please note that all connected speakers are turned off automatically while the headphones plug is inserted in the phone jack. One may switch on or off both sets together or separately. Press the speakers button to toggle through the four speaker selections: Off, pair A, pair B and pairs A+B. Release the speakers button to stop the sequence. TONE SELECTOR Press the Tone button to toggle through the four selections: Off, B (Bass), M (Medium) and T (Treble) indicator G. Adjust the level of B, M (Attention, you can listen the medium adjustment after one second) and T with the volume/control button from -10 to +10 (indicator C) When the adjustment is done, wait 5 secondes and your adjustments will be memorised automatically. The MAX-450 integrates a direct mode signal that could be activate by pushing the Tone button (the display will show Off). When the direct Tone is on, the tone controls are bypassed, so you can enjoy a pure sound. PC1, PC2, iPod AND USB INPUTS Press the PC/iPod/USB button to toggle through the four selections: PC1, PC2, iPod and USB. PC1, iPod and USB inputs are located on the front panel. PC2 inputs are located on the rear panel. In Off mode, the audio signal coming from your PC1 or iPod is not going thru the optimizer processor. In mode 1, 2, 3 and 4, the audio signal coming from your PC or iPod is optimised to obtain a more “audiophile“ sound. LEVEL PC1/iPod Press this button to boost the audio signal coming from your PC1 or iPod. Class’A) HIGH BIAS LIGHT INDICATOR This light indicator is ON when High Bias function is active. IPod MINIJACK INPUT You can connect your iPhone or iPod with a minijack (3, 5mm) male cable. Also, you can use a specific 30pins/minijack 3, 5mm cable. USB B AUDIO INPUT (MAC OR PC) The USB audio input can be used to play audio files from your PC or MAC. installation should be automatic and no driver disc is required. Afficheur I When connecting your PC on the USB B audio input, the description will be displayed as “USB Audio CODEC”. [. . . ] POWER CORD / VOLTAGE SELECTOR You need to be sure about the voltage of your country. In case that you need to use your appliance in 115V, you need to change the position of the voltage. Before plugging in the amplifier, its master power switch must be in the OFF position. COAXIAL DIGITAL (2) AND OPTICAL (1) INPUTS Your amplifier integrate a DAC (Digital audio converter) with 3 inputs, 2 are coaxials and 1 is optical. [. . . ]