User manual ADVENT ADR660

[. . . ] Congratulations on your purchase of this remote. This universal remote makes juggling remote controls a thing of the past. You can program your universal remote to operate most models of most brands of infrared, remote-controlled components manufactured after 1990. (See the enclosed Code Lists for a complete list of brands. [. . . ] Once programmed successfully, the TV key controls the TV functions, and the VCR or DVD key controls the VCR or DVD functions, respectively. there is a specific section in the Code Lists for combo units. The codes in this section should be tried first using Direct Code Entry on the TV, DVD, VCR, or AUX key(s). If this is unsuccessful, follow the normal programming methods for both the TV and the DVD or VCR keys. ⷠMake sure the batteries are fresh and are properly installed. Make sure your components are turned on and your TV is set to display the appropriate video source. ⷠYou must put the remote in the correct mode by pressing the corresponding component key (TV, DVD, VCR, AUX, SAT· CBL) so the remote knows which component you want to operate. You may have pressed an invalid key for the mode the remote is in. ⷠIf you're trying to change channels, try pressing the OK key after entering the channel number as this is a requirement of certain models and brands. ⷠThere is a possibility that a programmed code may only be able to control some of your component features (e. To confirm that the component key is programmed with the correct code for maximum functionality, test the component. attempt to control a variety of the component's functions with the remote. If some of the features of your components do not work, try programming the remote with a different code in the list using the Direct Code Entry Method, until you find the code that allows the remote to control the majority of your component's functions. Different codes can provide different levels of functionality. Make sure your components are turned on and your TV is set to display the appropriate video source. ⷠYou may have pressed an invalid key for the mode the remote is in. You must put the remote in the correct mode by pressing the corresponding component key (TV, DVD, VCR, AUX, SAT· CBL) so the remote knows which component you want to operate. ⷠMake sure the batteries are fresh and are properly installed. Replace the batteries with two new AAA batteries, if necessary. Make sure the tape is not write-protected. If the safety tab is removed the tape is write-protected, and you cannot record onto that tape. Make sure your components are turned on and your TV is set to display the appropriate video source. [. . . ] If this happens, just press the MENU/GUIDE key again, and then retry your selection. EXITING A MENU/GUIDE MODE The remote automatically times out of Menu/Guide Mode after 20 seconds of inactivity (no keys being pressed). at that time , the remote clears the displayed menu from the TV. If you want to exit the Menu/Guide Mode yourself, press the corresponding component key on the remote (TV, DVD, VCR, AUX, SAT· To confirm that the component key is programmed with the correct code for maximum functionality, it is necessary to test the component. [. . . ]