User manual AEG-ELECTROLUX 115EW

[. . . ] 10 Stainless steel surfaces . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 11 Grease filter . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 12 Something not working . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 18 Service and spare parts . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] It is always possible to select a suitable height and suction speed depending on what you fry and cook. In addition to height and extraction speed you can select extraction direction. The worktop extractor can be set to suck equally from the right and left or to suck only from the right or the left. When the worktop extractor is installed together with a gas hob, the worktop extractor must only be load in the upper position. See the "installation" section. Top cabinet Black plastic tube Grease filter Plastic tray End pieces 5 Pilot light The pilot light is located on the front of the product. The pilot light comes on when the product is switched on and extinguishes when the product is switched off. Control button Pilot light The extraction capacity of the worktop extractor The extraction capacity is 370m³/h at the high extraction speed and 211m³/h at the low extraction speed. The extraction capacity of the worktop extractor is reduced with every bend of the vent hose/duct. The capacity is also reduced in proportion to any increase in the length of the vent hose/duct. The less resistance the exhaust air meets, the better the extraction capacity and the less noise from the worktop extractor. If an installation has a 6 m long vent hose (with a diameter of 125 mm) and two 90° bends, the extraction capacity will become max. 330 m³/h and min 190m3/h. 6 How to use the worktop extractor Never leave the worktop extractor unattended while deep fat frying or heating fats and oils. The width of the hole is always: 490 mm for all combinations. The length of the hole equals the sum of the external measures of length of all the units - 20 cm. Minimum distance to side wall: 150 mm Minimum distance to rear wall (nonflammable material): 50 mm Reinforcement beams 13 Fitting reinforcement beams All 145 mm and 290 mm units come with a reinforcement beam. A reinforcement beam must be fitted between each unit. The beam should not be screwed onto the worktop, but be kept in place by the frame section of the units. 145 mm: Worktop extractor 290 mm: Ceramic glass with two hotplates Gas with two burners Solid plate with two hotplates Combi-grill/fryer Ceramic grill Wok Fryer 580 mm: Ceramic glass with four hotplates Gas with four burners 720 mm: Ceramic glass with four hotplates The capacity is also reduced in proportion to any increase in the length of the vent hose/duct. The less resistance the exhaust air meets, the better the extraction capacity and the less noise from the worktop extractor. If an installation has a 6 m long vent hose (with a diameter of 125 mm) and two 90° bends, the extraction capacity will become max. 330 m³/h and min 190m3/h. The extraction capacity of the worktop extractor The extraction capacity is 370m³/h at the high extraction speed and 211m³/h at the low extraction speed. The extraction capacity of the worktop extractor is reduced with every bend of the vent hose/duct. 14 Installation This extractor unit must be installed according to the instructions supplied. Any electrical installation work must be undertaken by a qualified electrican/competent person. Do not alter the specifications or attempt to modify the appliance in any way. [. . . ] Replace if necessary If after all these checks, your appliance still does not operate correctly, contact your local AEG Service Force Centre. In-guarantee customers should ensure that the above checks have been made as the engineer will make a charge if the fault is not a mechanical or electrical breakdown. AEG reserves the right to stipulate the place of repair (i. e. , the customer's home, place of installation or AEG workshop). The guarantee or free replacement includes both labour and materials. [. . . ]