User manual AEG-ELECTROLUX 12550G-FM

[. . . ] Subject to change without notice Thank you for choosing one of our high-quality products. To ensure optimal and regular performance of your appliance please read this instruction manual carefully. It will enable you to navigate all processes perfectly and most efficiently. To refer to this manual any time you need to, we recommend you to keep it in a safe place. [. . . ] Pots must not occupy any part of the control zone. Before carrying out any operation, disconnect the appliance from the power supply and allow it to cool. Clean the hob regularly with a soft cloth soaked in lukewarm water and a little liquid detergent. Do not use the following products: - household detergents or bleaches; - soapy scouring pads unsuitable for non-stick pots/pans; - steel wool; - bath or sink stain removers. If the hob is very dirty, use specific products available on the market. If you notice any breakage or cracks on the glass top, immediately disconnect the appliance to avoid risk of electric shocks, contact an After-Sales Service Centre and do not use the appliance until it is repaired. The grates can be removed from the hob to enable better cleaning. Keep the cast iron grates in their seats, to avoid scratching or damaging the hob. The grates cannot be placed in a dishwasher; after washing by hand, make sure to correctly refit them. Carefully clean these parts of the hob periodically. Also, to avoid difficult lighting make sure the flame spreader holes are not clogged. Have the condition and efficiency of the gas pipe and the pressure regulator (if present) periodically checked. In case of any anomalies, have the faulty part replaced (and not repaired). ATTENTION: This appliance can only be installed and used in permanently ventilated places in conformity with UNI 7129 and UNI 7131. The manufacturer declines any liability for damage due to installation not complying with the current standards or failure to respect the accident-prevention regulations. Appliance installation and connection to the power supply must only be carried out by QUALIFIED PERSONNEL. Before carrying out any operation, make sure the appliance is DISCONNECTED from the power supply. For correct operation of the gas appliance, the air necessary for gas combustion must be able to flow naturally in the room. (The installer must comply with the current UNI-CIG 7129 - 7131 standards). The air must flow into the room through openings made in the external walls. These openings must have a free open section of at least 100 cm2 if the appliance is equipped with a safety device or 200 cm2 if the appliance does not have a safety device. This opening must be located near the floor, preferably on the opposite side to fume extraction, and be made in such a way that it is not obstructed from the inside or outside. [. . . ] The hob can be fitted in a cabinet having an opening of the size illustrated. The opening must be at least 55 mm from the rear wall. Any right or left side wall higher than the hob must be at least 100 mm from the recess in the top. The hob must be fixed to the cabinet as follows: 1) Prepare the hole in the top according to the measurements indicated. [. . . ]