User manual AEG-ELECTROLUX 125ELTBL

[. . . ] Please consult the assembly instructions for operating the hood in extraction mode. 4 Electrical connection for the UK Appliances with 2 wires WARNING: DOUBLE INSULATED - DO NOT EARTH The appliance must be connected to fixed wiring with a double pole switched fused spur outlet with or without pilot lamp. We strongly recommend the appliance to be connected only by a qualified electrician who is a member of the NICEIC who will comply with the IEE and any local regulations. NOTE: The terminology DOUBLE POLE means that both the live and the neutral supplies are switched and disconnected at the same time. The terminations labelled SUPPLY are for the connection for the internal house wiring and the terminations labelled LOAD are for the appliance. [. . . ] q Since the rule for rooms with fuel burning appliances is outlet hole of the same size as the ventilation hole, a hole of 500-600 cm2, which is to say a larger hole, could reduce the performance of the extractor hood. q If the hood is used in its filtering function, it will operate simply and safely in the above conditions without the need for any of the aforementioned measures. q When the hood is used in its extractor function, the following rules must be followed to obtain optimal operation: short and straight outlet hose keep bends in outlet hose to a minimum never install the hoses with an acute angle, they must always follow a gentle curve only keep the hose as large as possible (120 mm Ø min. ). q Failure to observe these basic rules will drastically reduce the performance and increase the noise levels of the extractor hood. 8 Wall mounting q Fix the drilling template to the wall. q Make 3 Ø 8mm holes in the wall 2 at points I, 1 as desired at points L. q Insert the three Ø 8mm expansion plugs into the wall. q Insert 2 5x45 screws at points I but do not tighten them completely. q Adjust the unit so that it is positioned at a right angle to the wall by turning the two support screws G. q Fit the hood into holes I, tighten the 2 screws. q From inside the hood, insert the third 5x45 screw into hole L. 4. 4 q Measure the height between the upper side of the body of the cooker hood and the ceiling (fig. Note: when washing the metal grease filter in the dishwasher a slight discoloration of the filter can occur, this does not have any impact on its performance. q Clean the inner housing using a hot detergent solution only (never use caustic detergents, abrasive powders or brushes). 13 Removing the filter Open the grid and remove the stops M to take out the filter. 6. Carbon filter q The activated carbon filter should only be used if you want to use the hood in recirculation mode. q To do this you will need an original AEG activated carbon filter (available as an accessory). q This filter cannot be cleaned or reused. q As a general rule, the activated carbon filter should be changed once every four months. Fit first rearwards on the proper seats. Then fix frontwards the carbon filter using hooks C. q Dismounting : Unhook the carbon filter from its housing pushing hooks C. 11 q Always specify the hood model code number and serial number when ordering replacement filters. This information is shown on the rating plate located on the inside of the unit. q The activated carbon filter can be ordered from AEG Servire Force. 14 Warning q Failure to observe the instructions on cleaning the unit and changing the filters will cause a fire hazard. [. . . ] Symptom The cooker hood will not start. . . Solution Check that: The hood is connected to the electricity supply. Check that the fan speed control is set to 1, 2 or 3. Chec k that: The fan speed is set high enough for the task. [. . . ]