User manual AEG-ELECTROLUX 12700

[. . . ] ÖKO-LAVAMAT 12700 TURBO ELECTRONIC The environmentally friendly washer-dryer La lavadora-secadora ecológica Instruction booklet Instrucciones para el uso ÖKO_LAVAMAT TURBO F 1200 1000 900 700 400 D C B A 30 40 30 40 40 40 95 E 60 50 40 30 60 50 12700 AUS ERFAHRUNG GUT Dear customer, Please read these operating instructions carefully and pay particular attention to the safety notes indicated in the first pages. We recommend that you keep this instruction booklet for future reference and pass it on to any future owners. The warning triangle and/or the key words (Warning!, Caution!) emphasize information that is particularly important for your safety or correct functioning of the appliance. This symbol guides you, step by step, in the operation of the appliance. [. . . ] If you wish to perform a prewash, a SOAK or a STAIN-Action programme, pour detergent or stain remover into compartment . Do not use normal detergent for the STAIN-Action programme, always use a STAIN remover. Pour the fabric softener into compartment "MAX" mark. Close the drawer gently, pushing it fully in. without exceeding the 24 25 How to wash How to wash Selection of the desired wash programme Turn the programme selector dial to the desired position: the lights corresponding to the different phases making up the selected programme light on. The display shows the duration of the programme. F D C B A 30 40 30 40 95 EXTRA RINSE E 60 50 40 30 60 50 40 40 This appliance is designed for saving water. However, for people with a very delicate skin (allergic to detergents) it may be necessary to rinse the laundry using an extra quantity of water (extra rinse). The extra rinse is available only with the cotton, synthetics or delicate programme. Selection of the EXTRA RINSE option Selection of the desired options depending on the degree of soil of the laundry. Press simultaneously the buttons and for about 2 seconds: the light comes on in the programme progress display. To remove it press the buttons and again until the light comes off. Selection of the spin speed or RINSE HOLD option It is possible to select a lower spin speed by means of the relevant button; the light corresponding to the selected speed comes on. Selecting the option (RINSE HOLD) the laundry is left immersed in the final rinse water. 1200 1000 900 700 400 Selection of the DELAY START option To delay starting of a programme, press the DELAY START button before starting the machine. The figures corresponding to the selected delay will be displayed for about 5 seconds, after which the duration of the selected programme will appear on the display. If the button (SOAK) has been pressed the selected delay will correspond to the soak time. If no delay time is selected the soak programme will last about 30 minutes. When the START/PAUSE button is pressed, the selected delay will appear again on the display and the machine starts its countdown. If the spin speed is not reduced , the final spin speed will be as follows: - cottons 1200 r. p. m. - wool (hand washing) 900 r. p. m. 26 27 How to wash How to wash Starting the programme 1. Press START/PAUSE to start the programme. If the Delay Start option has been selected the programme will start at the end of the countdown. If the door light is red and flashing at the start of the programme it indicates that the door is open. Close the door and press the START/PAUSE button again. If the delay start option has been selected, the machine starts its countdown, in hours, which will appear on the display. During this period it is possible to load other laundry, to modify or cancel the delay time. [. . . ] · Please ensure that when the appliance is installed, it is easily accessible for the engineer in the event of a breakdown. Remove the polystyrene block from the bottom of the 2 machine and 1 release the two plastic bags which are fixed under the filter door. Carefully remove the right-hand bag (1) then the left-hand bag (2) by pulling them towards the centre of the machine. Set the machine upright and remove the two remaining bolts from the back. Pull out the three plastic spacers from the holes into which the bolts were fitted. [. . . ]