User manual AEG-ELECTROLUX 131FF-M

[. . . ] INSTRUCTION BOOK GB 131 FF-m SGP/ZA 1 949600692 Congratulations from AEG Dear Customer, Congratulations with your new Hob. It is important that you become familiar with the functions and features of the Hob. You should therefore read these operating instructions as they will help you get the most out of your new Hob. Pay extra attention to sections marked . [. . . ] Therefore please wash the frying container, basket and the heating element in hot water with washing-up liguid. Pour 3 liters of water with some detergent into the frying container. Warm up the water and let it boil for about 10 minutes. Empty the water into a bowl through the bottom tap and flush with hot water. Before using the chip-fryer, fit the enclosed metal filter over the drain hole in the base of the 5 Please keep childeren out of reach!!Rember that the heating elements and the frying oil remain searing hot for a long period after you have turned off the appliance. If the frying oil catches fire, turn off the extractor hood. Suffocate the fire by covering it with the lid, a pan, baking tray or similar object. Never try to put out the fire with water. Steel cover The cover supplied may only be used on this model. 6 Description of the product Steel cover Frying basket Max. oil level Control lamp Heating element for fryer Control knob 7 How to use Operation of the fryer Control knob for fryer. The temperature is regulated by a thermostat and may be set between 120°C and 190°C. Controllamp for the fryer Kontrolleuchte für die Friteuse 190° Control lamp The control lamp will light when the fryer is switched on and will switch off when the set temperature is achieved. The light will come on and off in line with the thermostat regulation of the temperature. 170° Frying Make sure the heating element is positioned at the bottom. Oil is poured into the frying container. The "Min" mark must be observed. This corresponds to an oil content of 1, 5 liters. Maximum amount of oil in the container is 3, 5 litres. The heating elements stay turned down and the fryer may be switched on at the desired temperature setting. The lid may be on the fryer to shorten the preheatingtime. 8 Overheating protection Overheating protection during any overheating of the oil at the fryer will switch the inserted overheating protection off the friteuse. Customer service for the remedy of the disturbance contacts. Steel lid for the fryer When using the combi-grill as a fryer you can place the steel lid on top of the frying container, it will shorten the preheating time. 9 Maintenance and cleaning The heating elements and the oil will stay hot long time after the fryer has been shut off. Do never pour water into the hot oil as the water explosiverly will start boiling Panel Taking off the panel You can take the panel off, which makes it easier to clean the surface. Hold the panel as shown in the diagram 2. Clean the top surface as shown under "cleaning the steel surface" Beware of the two pegs, which are sharp 4. [. . . ] Remember that moist foodstuff should be dried before frying (ie. After frying the basket is lifted out and carefully shaken to remove excess oil (the basket may be hung on the fixing bracket in order to let the oil run off further). In the table the approximate times are given for frying, which may serve as a guide. The times depend on the finished appearance and personal taste. [. . . ]