User manual AEG-ELECTROLUX 1400D-M

[. . . ] q If the fumes must be forced out through the wall, you must obtain a MKZ sizable wall exhaust pipe (with external exhaust and air intake), E-Nr. - 610 899 004 (Ø 120 mm) which is one of our optional parts. q When installing the hood, make sure you respect the following minimum distance from the top edge of the cooking hob/ ring surfaces: electric cookers gas cookers coal and oil cookers 600 mm 650 mm 700 mm min. 57 q The national decree on fuel-burning systems specifies a maximum depression of 0. 04 bar in such rooms. q The air outlet must not be connected to chimney flues or combustion gas ducts. The air outlet must under no circumstances be connected to ventilation ducts for rooms in which fuel-burning appliances are installed. [. . . ] 4. Hand washing Soak grease filters for about one hour in hot water with a grease-loosening cleaner, then rinse off thoroughly with hot water. Refit the grease filters when it are dry. Q Q N N Dishwasher machine Place grease filters in dish washer. Select most powerful washing programme and highest temperature, at least 65°C. Refit the grease filters when it are dry. When washing the metal grease filter in the dishwasher a slight discoloration of the filter can occur, this does not have any impact on its performance. q Clean the inner housing using a hot detergent solution only (never use caustic detergents, abrasive powders or brushes). 61 Fig. 4 Carbon filter q The activated carbon filter should only be used if you want to use the hood in its filtering function. q To do this you will need an original AEG activated carbon filter (see special accessories). l Cleaning/replacing the carbon filter Unlike other carbon filters, the LONGLIFE carbon filter can be cleaned and reactivated. At normal use the filter should be cleaned every second month. The best way to clean the filter is in the dishwasher. Use normal detergent and choose the highest temperature (65º C). Wash the filter separately so that no food parts gets stuck on the filter and later causes bad odours. To reactivate the carbon, the filter should be dried in an oven for 10 minutes with a temperature of maximum 100º C. After approximately three years of use, the carbon filter should be replaced with a new, as the odour reduction capacity will be reduced. l Mounting Remove the grease filters and fit one LONG LIFE carbon filter S on the rear side of each grease filter, fix each with two metal wires Z . q Always specify the hood model code number and serial number when ordering replacement filters. This information is shown on the registration plate located on the inside of the unit. q The activated carbon filter can be ordered from the AEG technical assistance service. S S Z Fig. 5 62 Warning q Failure to observe the instructions on cleaning the unit and changing the filters will cause a fire hazard. [. . . ] l From inside the cupboard, insert the 4 supplied screws (5) and tighten them in the appropriate holes on the appliance. Fig. 7 q Sign a centerline onto the wall (1). q Fix the drilling template to the wall. q Make 3 Ø 8mm holes in the wall (3), 2 at upper points, 1 as desired at lower points. [. . . ]