User manual AEG-ELECTROLUX 2002F-W

[. . . ] This type of operation is chosen when there is no outlet connection to the outside or when it is not possible to install one. You will need to ask your supplier or technical assistance centre for an activated carbon filter for this type of operation, stating the hood model for which it is required. q You will need an original AEG KF2000 activated carbon filter for the filtering function. q Unplug the unit or disconnect it from the power supply q Remove the metal grease filters. [. . . ] q Fix the hood into its final position using 2 screws (Ø 5x45 mm). 5 35 q Remove the telescopic chimney support M by unscrewing the side screws R (one on each side - these screws must be kept). q Remove the air pipe L from the telescopic chimney support M ; to do this, unscrew the four screws (Ø 2, 9 x 9, 5 mm) fixing the air pipe to the support (these screws must be kept). q Fit the telescopic chimney support to the wall, at a point close to the ceiling. The telescopic chimney support has a reference mark P , which must coincide with the line that you have already drawn on the wall. q Using a pencil, mark the two holes required to fix the support, and drill the holes (Ø 8 mm). q Insert two plugs and fix the telescopic chimney support M using 2 screws size (5x45 mm). q During installation the plug must not be connected to the power supply. M M R L R R P R Fig. 6 36 Select the hood operating mode q Extractor operation Fix the 150 mm diameter ABS pipe to the hood outlet and ensure that the other end discharges into the open air. The hood is supplied with a reducer for 120 mm diameter pipes. This reducer must be mounted on the hood outlet. = Increase fan speed button for increasing speed of motor from 1 to 9 and high speed (P). q If the hood fails to operate correctly, briefly disconnect it from the mains power supply for almost 5 sec. Then plug it in again and try once more before contacting the Technical Assistance Service. q Always press the key before disconnecting the hood supply. from the mains supply. 39 Setting the fan speed Fig. 9 q Press the ( ) button (F) to select the fan speed from 1 to 9, keeping it pressed until the speed you want, e. g. q If you accidentally set a higher speed than you want, press the decrease speed button ( ) (E) until the correct speed is shown on the display (D). 9 9. Hood lighting q Simply press the ( or off. ) button (A) to switch the lighting on 40 Intensive speed P Fig. 10 q To select the intensive speed (P), press the increase speed button ( ) (F) until the letter P (high speed) is shown on the display (D). q Press the ( ) button (E) to slow down from intensivespeed operation. [. . . ] q The correct "residence time" can only be obtained using original AEG activated carbon filters (see Special Accessories). 43 Display warning on saturation of activated carbon filter q After 120 operating hours, the letter (C) (activated carbon filter) will flash on and off on the display (D) in alternation with the fan speed setting. 13 q This means the activated carbon filter needs to be changed!(This operation should be carried out every 120 operating hours!). The metal grease filters must be cleaned when you change the activated carbon filter. 44 q Proceed as follows to remove and change my activated carbon filter: button. [. . . ]