User manual AEG-ELECTROLUX 2020D-M

[. . . ] 2020 D Cooker Hood Operating and Installation Instructions For the User Important Safety Information Your Appliance For the Installer Installation Instructions Technical Information Electrical Connections Operating Instructions Cooker Hood Controls To Operate Recirculation Extraction Electrical Requirements Electrical Connection Installing the Cooker Hood Installation Requirements Unpacking Clearance Height Selecting the Type of Installation Fixing the Chimney to the Canopy Fitting the Hood to the Wall Drilling the Shelves Bottom Shelf Top Shelf Installation in Recirculation Mode Installation with Air Outlet Turned to the Wall Installation with Air Outlet Turned Left or Right Final Fixing and Adjustment of Hood Ducting Recirculation Electrical Connection and Working Test Maintenance and Cleaning External Cleaning Metal Grease Filter To Remove the Grease Filter Cassette Charcoal Filter To Remove/Replace the Charcoal Filter Worktop Lighting Replacing the Light Bulb Something Not Working Service and Spare Parts Guarantee Conditions Guide to use the instruction book The following Symbols will be found in the text to guide you through the instruction book Safety instructions Step by step instructions 2 IMPORTANT SAFETY INFORMATION These warnings are provided in the interests of your safety. Ensure that you understand them all before installing or using this appliance. If you are unsure about any of the meanings of these warnings contact the Customer Care Department. Installation · · Any installation work must be undertaken by a qualified electrician or competent person. This hood must be installed in accordance with the installation instructions and all measurements adhered to. [. . . ] · The guarantee is for the same period and to the same extent for labour and parts as exists in the new country of use for this brand or range of products. · The product is installed and used in accordance with our instructions and is only used domestically, i. e. · The product is installed taking into account regulations in your new country. Before you move please contact your nearest Customer Care centre, listed below, to give them details of your new home. They will ensure that the local Service organisation is aware of your move and able to look after you and your appliance. Incorrect installation may affect the safety of this cooker hood. Installation Requirements Before installation check the wall to which the cooker hood is to be fitted for electric cables, water pipes or gas. The cooker hood is designed to be fixed to any rigid vertical surface over a cooking area, and can be used in the extraction (ducted to the outside) or recirculation (internal recycling) mode. The Installation work must be undertaken by a qualified and competent person. The manufacturer disclaims any responsibility to damages due to incorrect installation of the cooker hood or if the cooker hood is not installed in compliance with relevant regulations controlling this type of installation. Unpacking Before unpacking the cooker hood position the carton with the arrows pointing upwards as illustrated on the carton. S F The canopy is supplied with the following components for installation: G 1 No. Canopy including controls and worktop illumination (C). Telescopic chimney stack complete with fan motor (A). Ducting conversion bend (W) Support Rod (B) B 11 INSTALLING THE COOKER HOOD Clearance Heights The cooker hood is designed to be fitted over a cooking appliance at the clearance heights stated, provided the maximum output of the appliance beneath does not exceed the maximums quoted in the Technical Specifications. If the output of the appliance below the cooker hood exceeds the maximum outputs quoted, please refer to the cooker manufacturer's installation instructions. A minimum clearance height of 650mm (25 1/2 ins) is required when installed above a built-in electric hob, or 700mm (27 1/2 ins) when installed above a built-in gas hob. A minimum clearance height of 685mm (27 ins) is required when installed above a slot-in electric oven, or 787mm (30 1/2 ins) when installed above a slot-in gas oven. When installed between adjoining wall cabinets, the wall cabinets must not overhang the hob and the distance beetween the underside of the cabinet and the worktop must be 450mm. If the height of the wall cabinet is less than 450mm a gap of 50mm must be maintained either side of the hob. This cooker hood must not be installed above a cooking appliance with a high level grill. Hob A: Built-in Electric Hob: B: Built-in Gas hob: C: Slot-in Electric Cooker: D: Slot-in Gas Cooker: 650mm minimum clearance 700mm minimum clearance 685mm minimum clearance 787mm minimum clearance G S07_03 2a 3 R W Selecting the type of installation: The extraction unit at the top of the chimney can be installed in one of three ways. Air outlet turned upwards recirculation only (fig. Air outlet turned towards the wall -extraction only (fig. Air outlet turned left or right -extraction only (fig. 4a and 4b). 2. 4b W R 3. S07_30 4a 12 INSTALLING INSTRUCTIONS Fixing the Chimney to the Canopy 1. [. . . ] To fix the bracket (S), select the left or right hand screw holes and using the screw (V2) secure the bracket. Unscrew the four self tapping screws and remove the plastic surround. Fit the ducting spigot (R) using the four self tapping screws and replace the plastic cover. Fix the round eyelet screws provided tightly into holes (1) and hook on the canopy (C) ensuring the hooks are located into the eyelets before releasing the canopy. [. . . ]