User manual AEG-ELECTROLUX 2050D-M

[. . . ] The risk of self-ignition increases when the oil being used is dirty. It is extremely important to note that overheating can cause a fire. Never carry out any flambé cooking under the hood. Always disconnect the unit from the power supply before carrying out any work on the hood, including replacing the light bulb (take the cartridge fuse out of the fuse holder or switch off the automatic circuit breaker). [. . . ] The control switches are located on the units front panel: A - Main switch, hood on/off. B - Start and choice of motor speed 1-2-3-1-2. . . . . . . . . C - Indicates speed 1 (LED) and indication of the grease saturation for the filter (flashing indicator). D - Indicates speed 2 (LED) and indication of the active carbon saturation for the filter (flashing indicator). E - Indicates speed 3 F - Indicates Intensive speed (LED). The Intensive speed runs for 5 minutes: If the hood is on when the Intensive speed is activated, the hood revert to previous speed after 5 minutes. If the hood is off when the Intensive speed is activated, the hood will automaticly be turned off after 5 minutes. To interrupt the Intensive speed, press button A or B. H - Light ON/OFF Should the hood or the controls fail to operate: disconnect the power supply for at least 5 seconds, then turn the hood back on again. 55 Filter checking device for the detection of grease and active carbon This type of vapour hood is predisposed with a device that signals when the grease or active carbon filter requires cleaning (sold with the active carbon filter by the manufacturer specialized in ventilation equipment). This type of vapour hood is supplied by the manufacturer without the active carbon filter, therefore the saturation signal is disabled. The hood is purchased with active carbon filter included, and the saturation signal is activated as follows: Depress and hold the A and B buttons simultaneously for 3 seconds. This information is shown on the registration plate located on the inside of the unit. The activated carbon filter can be ordered from the AEG technical assistance service. A A Fig. 4 58 Warning Failure to observe the instructions on cleaning the unit and changing the filters will cause a fire hazard. You are therefore strongly recommended to follow these instructions. The manufacturer declines all responsibility for any damage to the motor or any fire damage linked to inappropriate maintenance or failure to observe the above safety recommendations. Changing the light bulb Disconnect the cooker hood from the main supply. Remove the lamp cover, use a screw driver as a lever. Replace the old bulb with a new one of the same type. If the light does not come on, make sure the bulb has been inserted in correctly before contacting the technical assistance service. Fig. 5 59 Cleaning Warning: always disconnect the hood from the mains power supply before cleaning it. Never insert pointed objects in the motors protective grid. Wash the outside surfaces using a delicate detergent solution. [. . . ] AEG reserves the right to stipulate the place of the repair (i. e. the customer`s home, place of installation or AEG workshop). The guarantee or free replacement includes both labour and materials. Repairs carried out under guarantee do not extend the guarantee period for the appliance. Parts removed during guarantee repairs become the property of AEG. [. . . ]