User manual AEG-ELECTROLUX 2084-2GT

[. . . ] · Do not let the mains cable of an appliance hang over the edge of a table or bench top or touch any hot surface. · Do not use the appliance with an extension cable unless this cable has been checked and tested by a qualified technician or service person. · Do not place an appliance on or near a hot gas flame, electric element or on a heated oven. Do not place on top of any other appliance. [. . . ] · When steam ironing, steam is emitted from the holes in the soleplate where if care is not taking, there is a risk of burns. · A steam iron takes approximately 30 minutes to cool down. Only store the appliance once it is cool and after emptying any remaining water. 3 When turned on for the first time, your new steam iron may give off vapours for up to 10 minutes. This is due to the initial heating of the materials used. It is safe, not detrimental to the performance of the steam iron, and will not reoccur. Filling the steam iron with water 1 Before filling the steam iron with water ensure that the plug is removed from the power outlet. The steam iron can be filled with water while it is hot. 1/G) to the "dry" setting. 4 822 949 465_2084-2GT. book Seite 5 Montag, 26. Januar 2009 9:45 21 g 0 Place the steam iron on its heel and open the filling aperture cover (Fig. 1/C). 0 Using the beaker provided, slowly pour water into the filling aperture until the maximum water level (Fig. Do not exceed the maximum water level indicator. 0 Push the filling aperture cover firmly to close. The steam iron is equipped with a drip-stop system. This system automatically stops water flowing to the steam chamber should the temperature fall too low to generate steam. This prevents dripping, even at low temperatures. Steaming hanging items of clothing Cleaning 0 To clean the exterior of the steam iron, wipe with a damp soft cloth and wipe dry. 3 1 Do not use harsh abrasives, chemical cleaners or solvents, as these will damage the surface. Cleaning the removable steam valve 0 To remove the steam valve, turn the steam selector anticlockwise to the "clean" setting so that the steam valve pops up (see Fig. 0 Gently scrub the tip of the valve with a steel wool soap pad moistened in warm water. 0 Replace the steam valve and turn clockwise to lock into position. The vertical steam jet function is ideal for steaming curtains, suits and delicate fabrics. 0 Hang the article concerned on a hanger and hold the steam iron at a distance of 10­20 cm from the material. 1/F). 3 Cleaning the steam holes 0 To remove scale build up in the steam holes that may affect your iron's steam performance, use a cotton wool tip moistened in methylated spirits. 1 Do not attempt to freshen up clothing whilst it is still being worn. Risk of burning! Care and Cleaning After each use 0 Turn the power off and remove the plug from the power outlet. 0 Allow the steam iron to cool before winding the cord around the builtin cord wrap (Fig. 1/N). Cleaning the Stainless Steal soleplate 1 Do not use scouring pads, abrasives or harsh cleaners to clean your soleplate, as these will scratch and damage the surface. [. . . ] Iron on wrong side while still damp or use spray to dampen. Steam can be used under manufacturer's instructions. Use an ironing cloth to prevent shine marks. Check label and follow manufacturer's instructions. [. . . ]