User manual AEG-ELECTROLUX 220D-D

[. . . ] You will need an original KFF activated carbon filter for filtering function. (See special accessories). Summer/Winter Hood Conversion q To avoid excessive heat loss during the winter months, we recommend that the hood be converted from outdoor ventilation to ventless operation (air recycling). q In order to convert the hood, a charcoal filter (special accessory) is required. Follow the instructions for operating the hood to recycle air. [. . . ] If you have any doubts, contact the relevant controlling authority or building inspector's office. q Since the rule for rooms with fuel burning appliances is "outlet hole of the same size as the ventilation hole", a hole of 500-600 cm2, which is to say a larger hole, could reduce the performance of the extractor hood. q If the hood is used in its filtering function, it will operate simply and safely in the above conditions without the need for any of the aforementioned measures. q When the hood is used in its extractor function, the following rules must be followed to obtain optimal operation: -- short and straight outlet hose -- keep bends in outlet hose to a minimum -- never install the hoses with an acute angle, they must always follow a gentle curve only -- keep the hose as large as possible (120 mm Ø min. ). q Failure to observe these basic rules will drastically reduce the performance and increase the noise levels of the extractor hood. 25 Wall unit mounting q Make the holes on the bottom of the cupboard, using the drilling template . q From inside the cupboard, insert the 4 supplied screws and tighten them in the appropriate holes on the appliance. 4. 2 1 4 3 2 1 4 3 4 26 Wall mounting q Fix the drilling template to the wall. q Make 3 Ø 8mm holes in the wall. 2 at points I, 1 as desired at points L. q Insert the three Ø 8mm expansion plugs into the wall. q Insert 2 5x45 screws at points I but do not tighten them completely. q Adjust the unit so that it is positioned at a right angle to the wall by turning the two support screws G. q Fit the hood into holes I, tighten the 2 screws. q From inside the hood, insert the third 5x45 screw into hole L. 5. 2 3 1 3 1 2 2 3 I L I L 1 I Fig. 6 5 I L G CLOSED L G OPEN 27 Hood Operation q The hood is fitted with a variable speed motor. The most effective use of the hood is obtained by switching it on a few minutes before you start cooking and leaving it on a for approximately 15 minutes after you have finished, thus ensuring all cooking odours are eliminated. The control switches are located on the unit's front panel: q the light switch switches the hood lamp on and off; q the motor switch switches the cooking smoke and vapour extractor motor on and off, enabling you to select one of the three different speeds and the intensive speed. OI O 123i Light switch On/Off Motor power adjustable to 3 positions + intensive 28 Safety warnings for user q Never leave a cooking hob or ring on without a pot or pan on top of it, to avoid the possibility of excess heat damaging the unit. Gas, oil or coal cooker flames in particular should never be left uncovered. q Special care should be taken when using deep fat fryers since the oil in them can overheat and burst into flames. q The risk of a fat fire increases when using dirty oil. q It is extremely important to note that overheating can cause a fire. [. . . ] You are therefore strongly recommended to follow these instructions. Changing the light bulb q Disconnect the unit from the mains power supply. q Replace the old light bulb with a new light bulb (40 W max. ). q If the light does not come on, make sure the bulb has been screwed in correctly before contacting the technical assistance service. Cleaning q Warning: always disconnect the hood from the mains power supply before cleaning it. Never insert pointed objects in the motor's protective grid. [. . . ]