User manual AEG-ELECTROLUX 2354GT

[. . . ] Adjust the flame intensity to direct it onto the bottom of the pan only, making sure that it does not engulf the sides. Deep fat fryers must be continuously monitored during use: overheated oil can burst into flames. Do not flambè under the range hood; risk of fire · The hood should not be used by children or persons not instructed in its correct use. maintenance · Switch off or unplug the appliance from the mains supply before carrying out any maintenance work. [. . . ] Clean and/or replace the Filters after the specified time period. Clean the hood using a damp cloth and a neutral liquid detergent. The symbol on the product or on its packaging indicates that this product may not be treated as household waste. Instead it shall be handed over to the applicable collection point for the recycling of electrical and electronic equipment. By ensuring this product is disposed of correctly, you will help prevent potential negative consequences for the environment and human health, which could otherwise be caused by inappropriate waste handling of this product. For more detailed information about recycling of this product, please contact your local city office, your household waste disposal service or the shop where you purchased the product. Ty Product Components 1 1 Hood Canopy complete with: Controls, Lights, Filters 2 1 Telescopic chimney made up of: 2. 1 1 Telescopic frame complete with Suction fan, made up of: 7. Use a plumb line to mark the centre of the hob on the ceiling/support shelf. Place the drilling template 21 provided on the ceiling/support shelf, making sure that the template is in the correct position by lining up the axes of the template with those of the hob. 1 is in correspondence with the Chimney openings both horizontally and vertically. Join the Connector 15 to the Hood canopy outlet us-ing a rigid or flexible pipe ø¸150 mm, selection of which is at the discretion of the installation technician. Position the upper chimney section and fix the upper part to the frame using the 2 screws 12c (2, 9 x 6, 5) provided. Similarly, position the lower chimney section and fix the lower part to the frame using the 2 screws 12c (2, 9 x 6, 5) provided. Before fixing the hood body to the frame: · Screw the 2 screws 12f half way into the holes provided in the sides of the bottom of the frame. Working from below, fix the hood canopy to the frame (B), using the 4 screws 12q and 4 washers 22 provided, then tighten all the screws securely Connect the hood to the mains through a two-pole switch having a contact gap of at least 3 mm. Place the connectors in the junction box 24 and close it using the 2 screws 12e (2, 9 x 9, 5) provided. Fix the junction box to the hood body using the 2 screws 12c (2, 9 x 6, 5) provided. Switches the extractor motor on and off at low speed. Used to provide a continuous and silent air change in the resence of light cooking vapours. [. . . ] Switches the extractor motor on and off at low speed. Used to provide a continuous and silent air change in the resence of light cooking vapours. Medium speed, suitable for most operating conditions given the optimum treated air flow/noise level ratio. Maximum speed, used for eliminating the highest cooking vapour emission, including long periods. [. . . ]