User manual AEG-ELECTROLUX 239D-M/UEB

[. . . ] If the instructions for installation for the gas hob specify a greater distance, this must be adhered to. Before any cleaning or maintenance operation, disconnect the hood from the mains by removing the plug or disconnecting the home mains switch. The appliance is not intended for use by children or persons with impaired physical, sensorial or mental faculties, or if lacking in experience or know-how, unless they are under supervision or have been trained in the use of the appliance by a person responsible for their safety. Children should be monitored to ensure that they do not play with the appliance. [. . . ] The cooker hood is designed to from extract unpleasant odours from the kitchen, it will not extract steam. The hood is supplied as an extractor unit and can also be used in recirculation mode by fitting a charcoal filter. In this mode fumes are extracted to the outside via a hose connected to the coupling ring ring. In order to obtain the best performance the hose should have a diameter equal to the outlet hole. The air is filtered through a charcoal charcoal filter and returned to the kitchen. You will need an original charcoal filter for the recirculation mode. Best results are obtained by using a low speed for normal conditions and a high speed when odours are more concentrated. Turn the hood on a few minutes before you start cooking. The hood should be left on after cooking for about 15 minutes or until all the odours have disappeared. The control switches are located on the unit's front panel: Before performing any maintenance operation, isolate the hood from the off removing electrical supply by switching off at the connector and removing the connector fuse. Through Or if the appliance has been connected through a plug and socket, then the removed from plug must be removed from the socket. Prior to touching the light bulbs ensure are ensure they are cooled down. Replace the old bulb with a new one of the same type (12V max 20W G4). If the light does not come on, make sure the bulb has been inserted in correctly before contacting your local Service Force Centre. Clean the outside of the hood using a damp cloth and a solution of water and mild washing up liquid. Only ever clean the switch panel and filter grill using a damp cloth and mild washing up liquid. Clean all the plastic parts with a soft cloth soaked in warm water and neutral soap. It is extremely important to clean the unit and change the filters at the recommended intervals. Failure to do so will cause grease deposits to build up that could constitute a fire hazard. If your appliance fails to work properly please carry out the following checks. Check that: The fan speed is set high enough for the task. The kitchen is adequately vented to allow the entry of fresh air. [. . . ] Before re-connecting the hood circuit to the mains supply and checking the efficient function, always check that the mains cable is correctly assembled. Power cable replacement must be undertaken by the authorized service assistance centre or similar qualified person. Do not connect the appliance to the mains until the installation is fully complete. For Extraction mode only: It is suggested to completely extract and reverse chimeny so that the oulet slots are not visible once installation has ended, Recirculation For Recirculation mode only: Check that the the exhaust slots on chimney are positioned upwards. [. . . ]