User manual AEG-ELECTROLUX 240D-M

[. . . ] · In order to convert the hood, a activated carbon filter (available as an accessory) is required. Follow the instructions for operating the hood to recirculate air. · When the temperature outdoors becomes more mild (spring), the filter can be removed and the hood converted once again for to extraction. Please consult the assembly instructions for operating the hood in extractor version. 71 Electrical connection Safety warnings for the electrician Before connecting the appliance to the power supply, check that the voltage indicated on the rating plate corresponds to the mains power supply available. [. . . ] · Adjust the unit so that it is positioned at a right angle to the wall by turning the two support screws G. · Fit the hood into holes I, tighten the 2 screws. · From inside the hood, insert the third 5x45 screw into hole L. 5 2 3 2 2 3 I L I L 1 3 1 1 I 5 Fig. 6 I L G CLOSED L G OPEN 76 Hood Operation · The control panel is located on the front of the hood. The control panel numbers and symbols (Fig. 6 from left to right) are explained in the key below: min 6 = Lighting, on/off. = Fan switch (speeds 1-3). min = Fan timer, 15 minutes. = Display showing fan speed (1-3), high speed (P), change grease filters (F) and change activated carbon filters (C). = Decrease fan speed button for reducing speed of motor from high speed (P) down to speed 1. = Increase fan speed button for increasing speed of motor from 1 to 9 and high speed (P). · If the hood fails to operate correctly, briefly disconnect it from the mains power supply for almost 5 sec. Then plug it in again and try once more before contacting the Technical Assistance Service. key before disconnecting the hood from the 77 Setting the fan speed A D E F 7 min · Press the button (F) to select the fan speed from 1 to 3, keeping it pressed until the speed you want, e. g. · If you accidentally set a higher speed than you want, press the (E) until the correct speed is shown on decrease speed button the display (D). Hood lighting · Simply press the button (A) to switch the lighting on or off. Intensive speed P C D E F min 8 · To select the intensive speed (P), press the increase speed button (F) until the letter P (high speed) is shown on the display (D). · Press the button (E) to slow down from intensive-speed operation. The speeds 9-1 will once again be shown on the display. 78 Fan timer · The hood should always be switched on before you start cooking and left on for approximately 15 minutes after you have finished. · Press the It will automatically switch off after 15 minutes operation at the selected speed. A red dot will flash on and off on the display (D). min Switching off the fan · Press the key (B) to switch off the fan at any speed including P. B D min 9 · After 5 seconds the number "0" (Fig. 9) will be shown on the display (D) followed, finally, by only the red dot. 10. D min 10 79 Hood operation before and after cooking · The hood should always be switched on before you start cooking and left on for approximately 15 minutes after you have finished (fan timer ). min Warnings on the activated carbon filter · The activated carbon filter should be replaced at least once every 120 operating hours. · The activated carbon filter cannot be cleaned or reused. · The effective elimination of cooking odours depends on the functional adaptation of the volume of activated carbon to the hood's air flow and a carefully determined position of the filter inside the hood. [. . . ] · Wash the outside surfaces using a delicate detergent solution. Never use caustic detergents or abrasive brushes or powders. · Only ever clean the switch panel and filter grille using a damp cloth and delicate detergents. · It is extremely important to clean the unit and change the filters at the recommended intervals. [. . . ]