User manual AEG-ELECTROLUX 2460D-A-GB

[. . . ] Failure to do so could cause grease deposits to build up, resulting in a fire hazard. For the Installer · When used as an extractor unit, the hood must be fitted with a 150mm diameter hose. · Should there already be a pipe of diameter 125 mm that ducts to the outside through the walls or roof, it is possible to use the 150/ 125 mm reduction flange provided. In this case the hood will be slightly more noisy. · When installing the hood, make sure you respect the following minimum distance from the top edge of the cooking hob/ring surfaces: electric cookers 500 mm gas cookers 650 mm coal and oil cookers 700 mm min. [. . . ] · Never insert pointed objects in the motor's protective grid. · Only ever clean the switch panel and filter grille using a damp cloth and mild detergents. · It is extremely important to clean the unit and change the filters at the recommended intervals. Failure to do so will cause grease deposits to build up that could constitute a fire hazard. Metal grease filter · The purpose of the grease filters is to absorb grease particles which form during cooking and it must always be used, either in the external ducted or internal recycling function. Attention: the metal grease filters must be removed and washed, either by hand or in the dishwasher, every four weeks. Open the metal grease filter · First, push the metal grease filter stop backwards, then extract the filter, pulling downwards. 3 Hand washing Soak grease filters for about one hour in hot water with a greaseloosening cleaner, then rinse off thoroughly with hot water. Refit the grease filters when they are dry. 8 Dishwasher Place grease filters in dishwasher. Select the most powerful washing programme and highest temperature, at least 65°C. Refit the grease filters when they are dry. When washing the metal grease filter in the dishwasher a slight discolouration of the filter can occur, this does not have any impact on its performance. 9 Charcoal filter · The charcoal filter should only be used if you want to use the hood in its filtering function. · To do this you will need an original AEG charcoal filter. · Replacing the charcoal filter The charcoal filters cannot be cleaned, we recommend that they should be replaced approximately every three months or more often if the hood is used for more than three hours per day. · Fitting Remove the frame b which supports the filter c by unscrewing it from the hood a, Fig. Insert the coal mattress inside the frame and put all parts back in their place. · To remove proceed in the reverse order. · Always specify the hood model code number and serial number when ordering replacement filters. This information is shown on the registration plate located on the inside of the unit. · The charcoal filter can be ordered from your local AEG Service Force Centre. Fig. 4 10 Warning · Failure to observe the instructions on cleaning the unit and changing the filters could cause a fire hazard. You are therefore strongly recommended to follow these instructions. · The manufacturer declines all responsibility for any damage to the motor or any fire damage linked to inappropriate maintenance or failure to observe the above safety recommendations. Changing the light bulb · · · · · Disconnect the cooker hood from the mains supply. Remove the lamp cover, use a screw driver as a lever. [. . . ] · From the inside of the hood mark two points for final fixing (10). · Remove the hood (11) and drill two holes Ø 8mm (12), fit two wall plugs (13). · Rest the chimney support bracket G against the wall, touching the ceiling. Use the support bracket as a drilling template and mark 2 holes with a pencil (14), dril the holes insert 2 wall plugs, fix the chimney support bracket to the wall using two screws (15) (If the hood is to be used in filter version, fix deflector F to the chimney support bracket G using 4 screws). [. . . ]