User manual AEG-ELECTROLUX 2490D-A

[. . . ] · Should there already be a pipe of diameter 125 mm that ducts to the outside through the walls or roof, it is possible to use the 150/ 125 mm reduction flange provided. In this case the hood will be slightly more noisy. · When installing the hood, make sure you respect the following minimum distance from the top edge of the cooking hob/ring surfaces: electric cookers 500 mm gas cookers 650 mm coal and oil cookers 700 mm min. · The national decree on fuel-burning systems specifies a maximum depression of 0. 04 bar in such rooms. [. . . ] · Clean the inner housing using a hot detergent solution only (never use caustic detergents, abrasive powders or brushes). 53 Carbon filter · The carbon filter should only be used if you want to use the hood in its filtering function. · To do this you will need an original AEG activated carbon filter (see special accessories). · Cleaning/replacing the carbon filter Unlike other carbon filters, the LONGLIFE carbon filter can be cleaned and reactivated. At normal use the filter should be cleaned every second month. The best way to clean the filter is in the dishwasher. Use normal detergent and choose the highest temperature (65º C). Wash the filter separately so that no food parts gets stuck on the filter and later causes bad odours. To reactivate the carbon, the filter should be dried in an oven for 10 minutes with a temperature of maximum 100º C. After approximately three years of use, the carbon filter should be replaced with a new, as the odour reduction capacity will be reduced. · Mounting Remove the frame b which supports the filter c by unscrewing it from the hood a, Fig. Insert the coal mattress inside the frame and put all parts back in their place. · To dismount proceed in reverse order. · Always specify the hood model code number and serial number when ordering replacement filters. This information is shown on the registration plate located on the inside of the unit. · The activated carbon filter can be ordered from the AEG technical assistance service. Fig. 4 54 Warning · Failure to observe the instructions on cleaning the unit and changing the filters will cause a fire hazard. You are therefore strongly recommended to follow these instructions. · The manufacturer declines all responsibility for any damage to the motor or any fire damage linked to inappropriate maintenance or failure to observe the above safety recommendations. Changing the light bulb · · · · · Disconnect the cooker hood from the main supply. Remove the lamp cover, use a screw driver as a lever. Replace the old bulb with a new one of the same type. If the light does not come on, make sure the bulb has been inserted in correctly before contacting the technical assistance service. Fig. 5 55 Cleaning · Warning: always disconnect the hood from the mains power supply before cleaning it. [. . . ] · From the inside of the hood sign two points for definitive fixing (10). · Remove the hood (11) and drill two holes Ø 8mm (12), fit two wall plugs (13). · Rest the chimney support bracket G against the wall, touching the ceiling. Use the support bracket as a drilling template and mark 2 holes with a pencil (14), dril the holes insert 2 wall plugs, fix the chimney support bracket to the wall using two screws (15) (If the hood is to be used in filter version, fix deflector F to the chimney support bracket G using 4 screws). [. . . ]