User manual AEG-ELECTROLUX 24968G-M

[. . . ] The burner controls are engraved graphically to indicate their associated burner and setting. 1) Select desired hotplate burner, depress control knob and gently turn anti-clockwise to "Full on" position whilst applying a lighted match to the burner. After the flame has established, adjust burner to desired setting. 1) Select desired burner, depress control knob and gently turn anti-clockwise to "Full on" position whilst depressing the electronic ignition switch (E) until flame has established. [. . . ] Stains may be removed by wiping with a clean cloth and soapy water before stains become cold. Stubborn stains may be removed by soaking in hot soapy water. Do not allow vinegar, coffee, milk, salty water, lemon or tomato juice to remain in contact with enamelled surfaces. FIG. 5 5 INSTALLATION TECHNICAL INFORMATION FOR INSTALLATION PERSONNEL WARNING: This appliance must be installed only by authorised personnel and in accordance with AS5601 (AG 601), the manufacturers installation instructions, relevant municipal building regulations, gas and electrical authority regulations. The wall and bench surfaces must be capable of sustaining temperatures of 75 degrees Celsius. All laminates, fixing adhesive and surfacing materials should be certified suitable for this temperature. Refer to figure 6 for required clearances around appliance. NOTE 1 : FIRE RESISTANT MATERIAL (eg CERAMIC TILES) IS REQUIRED TO 450 mm ABOVE BURNER TOP IF WALL OR VERTICAL STRUCTURES ARE WITHIN 200 mm FROM BURNER. NOTE 2 : RANGEHOOD AND EXHAUST SYSTEM ARE NOT PERMITTED WITHIN 600 mm ABOVE BURNER TOPS. 6) FIXING OF THE HOTPLATE THE CHILDREN SINCE THEY ARE A SOURCE OF POTENTIAL DANGER. 5) BENCHTOP CUTOUT The cutout in the bench-top should be made using the dimensions given in figure 7, 8 the template provided. NEVER LEAVE THE PACKING COMPONENTS (PLASTIC BAGS, NAILS, FOAMED POLYSTYRENE, ETC. . . ) WITHIN THE REACH OF The hotplate is provided with a special seal to prevent liquid penetrating to the underside of the appliance. For correct installation of this seal ensure the procedures detailed below are followed: - Unpack the sealing strips ensuring that the transparent protection is not damaged and remains attached to the seal. - Invert the appliance and fix the special clamps to the underside of the appliance with the screws "G" (see fig. - Carefully place the seal around the outer edge of the appliance. Care should be taken to align the outer edge of the seal with that of the appliance. Trim the seal to the correct length to ensure that no overlap of the seal occurs. - Adhere the seal to the appliance by pressing firmly with fingers. - Remove the protective strip from the seal. - Place the appliance into the cutout in the benchtop and secure with the special screws and fixing clamps. - It's necessary to fix a wooden division locked by screws at a minimun distance of 50 mm from the bottom of the hob if no oven is installed under the hob, is advisable also, to provide for drawers under the same. FIG. 11 6 INSTALLATION 7) GAS CONNECTION The gas connection is located at the rear and on the underside of the appliance 100 mm from the right hand side. Natural Gas Natural Gas installations require the connection of a gas regulator at the appliance. Assemble the regulator (noting the gas flow direction) and transition pieces, in accordance with figure 12. [. . . ] - Unscrew the threaded ring locking "D" the wok burner. - Remove the three plastic screws "O" at the rear of the appliance (86 cm models only). - Unscrew the center screw that lock the hotplate (86 cm models only). - Separate the top and bottom portions of the appliance. [. . . ]