User manual AEG-ELECTROLUX 3000HG

[. . . ] FORLI' Italy GENERAL INDEX GB I D NL F SP . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1÷9 INDEX Description 1. 0 1. 1 1. 2 1. 3 1. 3. 1 1. 3. 2 1. 3. 3 1. 3. 4 2. 0 2. 1 2. 2 2. 3 2. 3. 1 2. 3. 2 2. 3. 3 2. 4 3. 0 3. 1 3. 2 3. 3 4. 0 4. 1 4. 2 4. 3 4. 4 4. 5 4. 6 5. 0 5. 1 5. 2 5. 3 5. 3. 1 5. 3. 2 5. 3. 3 5. 3. 4 6. 0 6. 1 7. 0 8. 0 8. 1 8. 2 Page . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 10÷18 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 19÷27 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] 6 and 14. 2. 4 INSTALLING THE FUEL TANK Install the fuel tank as near as possible to the generator and if possible on the same horizontal level, or up to 30cm below. As well as reducing the length of fuel pipe as much as possible, make sure it is not bent or squashed. Do not put the tank near sources of heat, and make sure that water 3 FORLI' Italy cannot infiltrate. Use LOCTITE 577 to make all connections, so as to prevent fuel leakages. To connect the fuel tank to the generator, use a 6x13mm rubber-coated tube, of the same type used for the genset and suitable for unleaded petrol. For the extension, use the ties and filter provided. It is advisable to use fuel hose AG118 (accessory) for the connection from tank to refuellingmouth. DANGER · The unit shall be used only and exclusively with the door closed. · Keep inflammable substances like petrol, paints, solvents, etc. · Do not let hot parts of the genset come into contact with inflammable materials. · Do not fill up with the engine running if the tank is placed close to the generator. · Do not touch the generator or its connections with wet hands. · Do not replace the fuses or thermal switches with new ones of higher amperage. · Any check of the electrical parts shall be made with engine stopped and by authorised technicians only. IMPORTANT Model 5500 does not need fuel tank, since it is standard fitted inside the genset casing. CONNECTION TO GAS CANISTER CAUTION For the LPG genset, withdraw the gas from the upright canister before the vehicle's service regulator and from the upper part, so that gas enters the genset at high pressure and in the gaseous state. When starting the LPG generator from cold, press the green button (pos. 5) and at the same time "blip" the white button (pos. 5) for about a second at intervals of around 3 seconds. As soon as the engine fires, release both buttons. If the engine does not start, wait a few seconds, then repeat the operation. 4. 5 USEFUL ADVICES To use the genset at best, we remember you that little, but prolonged, overloads may cut off thermal switches pos. During running-in, it is advisable that the new engine is not subjected to loads exceeding its nominal load by 70%, at least during the first 50 running hours. CAUTION Do not make prolonged or repeated (more than 5 consecutive) attempts to start the genset, as this may damage the starter motor. 4. 6 TROUBLESHOOTING We have listed below some problems which may occur, along with their respective causes and possible solutions. In the case of problems which are not listed below, please seek advice from an authorised after-sales service centre. When the green "START" button (pos. 5) on the control board is pressed, the generator does not work. [. . . ] A loose spark plug can get very hot and damage the engine. 5. 3. 4 REGULATING THE VOLTAGE This regulation should be carried out with the engine warm and the generator running without a load. Check the generator voltage using a tester or voltmeter connected to the vehicle's 230V socket or to the terminals (pos. 6 and 14) of the generator terminal board. The voltage should be between 230 and 240 Volts. [. . . ]