User manual AEG-ELECTROLUX 302D-D-GB

[. . . ] 302 D Cooker Hood Installation and Operating Instructions Installing the hood to the wall It is possible to fix the hood in position, if necessary, by only attaching it to the rear wall. Drill the four holes on the wall as indicated (Fig. [. . . ] Check that the hood is at the right height. Minor height adjustments may be made with the screws U embodied in the brackets (see Fig. Tighten the two wall fixing screws R, through the two access holes N provided on the inside of the hood (Fig. 12) then fix the lower sliding frame to the hood with two screws O and washers previously unscrewed (item 4). 14 Using the hood It is advisable to switch on the cooker hood a few minutes before starting cooking and then to leave it running fot approximately 15 minutes afterwards to ensure that all odours are extracted. On the front of the appliance there are control switches (see page 3). The switch marked with motor symbol controls fan power. The switch marked with lamp symbol controls the lighting of the cooking surface. The hood is also fitted with an automatic micro switch located on the right hand side behind the visor, the micro switch will switch the hood OFF, whatever selection is made with the slider switches when the visor is closed. When the visor is pulled open the hood will switch ON at its previous setting. -- If the hood is run at the same time as an ambient-air dependent burner or fireplace (for example gas, diesel, coal or wood heaters, water heaters, etc. ) be careful, because the hood, when it extracts air, removes the ambient air the burners of fireplace need for combustion. For safe operation and to prevent discharged gas from coming back into the room, make sure there is an air inlet, which may be provided through air-recycling doors, windows or wall boxes or by other technical devices. -- No food must be cooked flambé underneath the hood. [. . . ] Where flexible ducting is fitted the length should be no more than: -- 3 metres with one 90° bend -- 2 metres with two 90° bends. Bends of more than 90° will reduce the efficiency of the hood and reduce the air flow. 15 AEG Hausgeräte AG Postfach 1036 D-90327 Nürnberg © Copyright by AEG H 260 251 240 L361C Ed. 06/95 [. . . ]