User manual AEG-ELECTROLUX 31050K

[. . . ] The indicator will turn off only when the temperature of the cooking zone will be below the value: this is the reason why we call it residual heat indicator. Some other models have only one indicator (see description paragraph). Connection of electric heating elements Heating elements are controlled by energy regulators with 12 positions or by commutators with 6 positions that permit a wide range of different temperatures. In Scheme 1, by way of information, we give instructions to obtain different cooking levels. [. . . ] Do not use metallic sponges, powder abrasives or corrosive sprays. Depending on the dirt level we recommend: - Slight stains: use a moist clean rag. - Burnt or soiling may be removed with a special razor scraper ( fig. 5 ); be aware that the razor can cause wounds. - Liquid marks, caused by boil-overs, can be removed using vinegar or lemon. - Pay attention not to let spilled sugar burn onto the element. In this case turn the switch off and clean the surface with hot water and the razor blade scraper. - After a period of time metal reflex and scratches (fig. 6) may appear due to the wrong cleaning and the wrong use of the pots. The scratches cannot be removed, but they do not compromise the good operating of the hob. - Don't use steam jets for the equipment cleaning. FIG. 6 6 INSTALLATION TECHNICAL INSTRUCTIONS FOR THE INSTALLER Installation may only be carried out by a competent technician or electrician. The ends of the strip must fit together without overlapping. - Stick the seal to the hotplate uniformly, pressing it with fingers. - Take the protective paper strip of the seal off, place the hotplate in the opening made in the table top, and lock it with the special screws "F"(fig. 12). 3) INSERTING After having cleared out all the packing components, make sure of the integrity of the appliance. Please keep children away from all packing materials (carton, polystyrene, nails, . . ). Make a cutout in the worktop, according to the dimensions indicated in fig. 7-8; make sure the critical dimensions of the space in which the appliance has to be installed (fig. 9) are respected. WARNINGS: Be aware that the glue joining laminated plastic to the wood, has to resist to temperatures above 150° C, to avoid delamination. [. . . ] 14 8 MAINTENANCE Before doing any repairs, disconnect the appliance from the input power. 6) COMPONENTS SUBSTITUTION To replace the components lodged in the internal part, is necessary to remove the appliance from the furniture, overturn it, loosen the screws and take off the bottom. After these actions it is possible to work on the plates, commutators, clamps and input cable. In case of substitution of the input cable, the installer must keep the "earth" conductor longer than "live" ones, and must respect the cautions in paragraph "electrical connection". To reassemble the appliance repeat the process inversely. 7) TECHNICAL CHARACTERISTICS OF THE ELECTRICAL COMPONENTS To facilitate the job of the installer we present a scheme with the characteristics of the components. POWER OF ELECTRICAL COMPONENTS DENOMINATIONS W Denominations Heating element Ø mm 145 radiant and halogen Heating element Ø mm 180 radiant Heating element Ø mm 180 halogen W 1200 1700 1800 TYPE AND SECTION OF THE POWER CABLES 4 HEATING ELEMENTS Cable type Single phase power 230 - 240 V~ Rubber H05 RR-F 3 X 2. 5 mm2 TYPE AND SECTION OF THE POWER CABLES 2 HEATING ELEMENTS Cable type Rubber H05 RR-F Single phase power 230 - 240 V~ 3 X 1. 5 mm2 9 TECHNICAL DATA MODEL WITH 4 HEATING ELEMENTS (2 RADIANTS + 2 HALOGEN) Voltage Frequency Tot. Rating 230 - 240 V~ 50/60 Hz 5900 W MODEL WITH 4 HEATING ELEMENTS (3 RADIANTS + 1 HALOGEN) Voltage Frequency Tot. [. . . ]