User manual AEG-ELECTROLUX 3108B-WGB

[. . . ] Built-in appliances may only be used after they have built in to suitable built-in units and work surfaces that meet standards. If there is a fault with the appliance, all hotplates must be switched off and the appliance must be disconnected from the mains supply to avoid any possible electric shock. Repairs to the appliance must only be carried out by trained, registered service engineers. 4 Safety during use There is the risk of burns from the appliance if used carelessly. Cables from electrical appliances must not touch the hot surface of the appliance or hot cookware. [. . . ] Switch the hotplates off after each use. Safety when cleaning For cleaning, the appliance must be switched off and cooled down. For safety reasons, the cleaning of the appliance with steam jet or high-pressure cleaning equipment is not permitted. How to avoid damage to the appliance Do not allow acid liquids such as vinegar, lemon juice or limescale removing agents to touch the hob, as otherwise this will cause matt patches. Do not place wet pan lids on the hotplates and do not allow hot pans to cool on the hotplates. Otherwise condensation and rust can form. Do not use the hotplates with empty cookware or without cookware. Do not use the cooking zones with empty cookware or without cookware. 5 Description of the Appliance Hob Features Hotplate 1500W Hotplate 2000W Oven steam outlet Hotplate 2000W Hotplate 1500W Using the Rings You operate the appliance with the combination appliance's ring switches. The operation and the function of the ring switches is described in the Operating Instructions for the combination appliance. Warning: The hotplates still remain hot for a time even after being switched off. Let the hotplates cool down. 1 6 Tips on Cooking and Frying Cookware You can recognise good cookware from the bottoms of the pans. The bottom should be as thick and flat as possible. Energy saving 2 2 2 2 Always place cookware on the hotplate before it is switched on. If possible, always place lids on the pans. Switch hotplates off before the end of the cooking time, to take advantage of residual heat. Instead it shall be handed over to the applicable collection point for the recycling of electrical and electronic equipment. By ensuring this product is disposed of correctly, you will help prevent potential negative consequences for the environment and human health, which could otherwise be caused by inappropriate waste handling of this product. For more detailed information about recycling of this product, please contact your local city office, your household waste disposal service or the shop where you purchased the product. 9 2 W Installation Instructions Safety instructions The laws, ordinances, directives and standards in force in the country of use are to be followed (safety regulations, proper recycling in accordance with the regulations, etc. ) Installation may only be carried out by a qualified electrician. The minimum distances to other appliances are to be observed. Drawers may only be installed with a with protective board directly under the appliance. The cut surfaces of the work top are to be protected against moisture using a suitable sealant. The sealant seals the appliance to the work top with no gap. Do not use silicon sealant between the appliance and the work top. Avoid installing the appliance next to doors and under windows. Otherwise hot cookware may be knocked off the rings when doors and windows are opened. [. . . ] Rated voltage of the combined appliances must match. Loose and inappropriate plug and socket connections can lead to overheating of the plug. Fit plug and socket connections together properly. A device must be provided in the electrical installation which allows the appliance to be disconnected from the mains at all poles with a contact opening width of at least 3 mm. [. . . ]