User manual AEG-ELECTROLUX 3201DK-W

[. . . ] 30 Replacement of connection cable. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 30 Warnings about building in the hob . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 31 Building in dimensions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 32 Cut out size . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] Repais carried out by unexperienced persons can cause damage or injuries. This hob should only be repaired or serviced by an authorised Service Engineer and only genuine approved spare parts should be used. This hob has been registered as a "Class Y" appliance according to Fire Risk Protection Regulations. It can be built-in in furniture units placed near higher walls or units, provided that one of the sides is adjacent to an unit with the same height. 23 Using the Hob Description of the appliance Rear Hotplate Front Hotplate Control Knob Rear Hotplate Control Knob Front Hotplate Operating Pilot Lamp Using the hob The knobs have 3 main heat settings, from "1" (minimum) to "3" (maximum), but they can also be set in every intermediate position, to adjust to personal needs. To switch on a cooking zone, turn the relevant control knob anticlockwise to the desired heat setting. Place a saucepans on the cooking zone before switching it on. Never leave the plates on without a pan on them or with an empty pan on them. Avoid leaving an hot saucepan on a cold plate, or leaving a hot saucepan to cool down on a switched off plate. This could cause condensation and damage the plate. Operating Pilot Lamp This lamp comes on each time a cooking zone is switched on. 24 Using the Hob For best cooking zone regulation, refer to the following table. 0 3 1 1 0 3 2 2 Control Knobs Operating Pilot Lamp Setting 0 · 1 · 2 · 3 Level best for OF F Simmering vegetables Fish in its own juice LOW Simmering potatoes or soups Boiling large quantities of food, stews and soups MEDIUM slow frying, making a roux Fast frying of meat or fish HIGH Rapid heating up of fat or water 25 Using the Hob Boiling To parboil, select setting 3 and turn back to 1 for boiling; use higher or lower setting as required. Frying Heat the fat up on setting 3, then insert food to be fried and turn back to 2; use higher or lower setting as required. Cookware Utensils with an even bottom should be used in any case, best if made of heatproof ceramic. Uneven pots and pans do not allow heat to be spread evenly throughout food, causing cooking times to be delayed and the hob to be damaged. Use utensils of a size matching the hotplates, or slightly larger, and place them exactly on the hotplates. If connecting the hob directly to the power mains, a double pole switch should be fitted, with a minimum gap of 3 mm. between the switch contacts and of a type suitable for the required load in compliance with the current electric regulations. The switch should be sited within 2m of the hob and be easily accessible upon completion of the installation. Proper arrangements must be taken in designing the furniture unit, in order to avoid any contact with the bottom of the hob which can be heated when it is operated. Before any intervention, ensure the hob is disconncted from the electricity supply. Once connection has been carried out, test heating elements for about 3 minutes. The minimum distance combustible material can be fitted above the hob in line with the edges of the hob is 420 mm. 29 Installation Electrical Connection This hob is provided with a connection cable type H05 V2V2-F T90, section 3 x 1, 5 mm2. A suitable plug must be fitted to the cable and then connected to a suitable plug, according with spexcification given on the rating plate. If connectiong the hob directly to the power mains, a double pole switch should be fitted, with a minimum gap of 3 mm. between the switch contacts and of a type suitable for the required load in compliance with the current electric regulations. The switch must not break the yellow and green earth cable at any point. [. . . ] Hanging furniture units or cooker hoods must be fitted at a minimum height of 650 mm. Combustible or not heatproof materials must be kept away from the appliance. 31 Installation Building in Dimensions 29 0 51 0 55 0 49 50 Rear wall 27 0 30 40 ÷5 0 Cut Out Size The dimensions of the cut-out are given in the diagram. hobs with different functions must be built in one beside the other (e. g. 2 Plate Hob + 2 burners Hob), the minimum distance shown in the diagram must be observed. 32 Installation Securing the hob into the cut out Before fitting the hob into the cut out, the sealing gasket supplied with the hob must be fitted to the edge of the cut out. [. . . ]