User manual AEG-ELECTROLUX 32253G9-M/GB

[. . . ] Persons (including children) with reduced physical sensory, mental capabilities or lack of experience and knowledge must not use the appliance. They must have supervision or instruction for the operation of the appliance by a person responsible for their safety. child safety · Only adults can use this appliance. Children must get supervision to make sure that they do not play with the appliance. [. . . ] There is the risk of injury from electrical current. ⷠDisconnect the appliance from the electrical supply, before you do the maintenance work or you clean it. Make electrical mains terminal free of voltage. A loose and incorrect mains plug and socket connections can make the terminal become too hot. Use the correct mains connection cable and replace the damaged mains cable with applicable cable. Speak to your local Service Force Centre. ⷠThe appliance must have the electrical installation which lets you disconnect the appliance from the mains at all poles with a contact opening width of minimum 3 mm. ⷠIf the fixing bracket is near to the terminal block, always make sure the connection cable does not come in contact with the edge of the bracket. You must have correct isolation devices: line protecting cut-outs, fuses (screw type fuses removed from the holder), ground leakage trips and contactors. disposal of the appliance · To prevent the risk of physical injury or damage ­ Disconnect the appliance from the power supply. ­ Cut off the mains cable where it connects with the appliance and discard it. Adjustment of minimum level To adjust the minimum level of the burners: 1. With a thin screwdriver, adjust the bypass screw position. If you change from natural gas to liquid gas, fully tighten the adjustment screw in. If you change from liquid gas to natural gas, undo the bypass screw approximately 1/4 of a turn (1/2 of a turn for Triple Crown burner). Make sure the flame does not go out when you quickly turn the knob from the maximum position to the minimum position. electrical connection · Ground the appliance according to safety precautions. ⷠMake sure that the rated voltage and type of power on the rating plate agree with the voltage and the power of the local power supply. ⷠThis appliance is supplied with a mains cable. It has to be supplied with a correct plug, able to support the load marked on the identification plate. Any electrical component must be installed or replaced by the Service Force Centre technician or qualified service personnel. Make sure that there is an access to the mains plug after installation. [. . . ] Always turn the flame down or switch it off before you remove the pans of the burner. If the burner does not light after 15 seconds, release the control knob, turn it into off position and try to When the liquid starts to boil, turn down the flame to barely simmer the liquid. Use pots and pans with bottom applicable to the dimension of burner. Do not use cooking vessels on the hotplate that overlap its edges. [. . . ]