User manual AEG-ELECTROLUX 32514DG-M

[. . . ] Accessible parts of this appliance may become hot when it is in use. Children should be KEPT AWAY until it has cooled. About Installation, Cleaning and Manteinance It is mandatory that all operations required for the installation are carried out by a qualified or competent person, in accordance with existing rules and regulations. Disconnect the appliance from the electrical supply, before carrying out any cleaning or manteinance work. Ensure a good ventilation around the appliance. [. . . ] 1 24 Lighting the burners F For easier lighting, proceed before putting a pan on the pan support. To light a burner, push in the relevant knob and turn it anticlockwise to "maximum position". After lighting the flame, keep the knob pushed down for about 5 seconds. This will allow the "thermocouple" (Fig. D) to be heated and the safety device to be switched off, otherwise the gas supply would be interrupted. Then, check the flame is regular and adjust it as required. If you cannot light the flame even after several attempts, check the "cap" (Fig. To put the flame out, turn the knob to the symbol l. FO 2295 A - Burner cap B - Burner crown C - Ignition candle D - Thermocouple Fig. 2 Always turn the flame down or put it out before taking the pans off the burner. Using the hob correctly To ensure maximum burner efficiency, it is strongly recommended that you use only pots and pans with a bottom fitting the size of the burner used (see table below), so that flame will not spread beyond the bottom of the vessel. It is also advisable, as soon as a liquid starts boiling, to turn down the flame so that it will barely keep the liquid simmering. Carefully supervise cookings with fats or oil, since these types of foodstuff can result in a fire, if overheated. Screw the parts without forcing, adjust the connection in the required direction and tighten everything. IMPORTANT - When the final connection has been made, it is essential that a thorough leak test is carried out on the hob and installation. Use some soapy water, never a flame. A) Ramp with ending nut B) Seal C) Adjustable connection FO 2365 Fig. 4 Ramp with ending nut Adjustable connection Fig. 5 Rigid or flexible gas pipe 29 Adaptation to different types of gas F Injectors replacement Remove the pan supports. FO 0392 Remove the burner's caps and crowns. With a socket spanner 7 unscrew and remove the injectors (Fig. 6), and replace them with the ones required for the type of gas in use (see Technical data). Reassemble the parts, following the same procedure backwards. Replace the rating label (placed near the gas supply pipe) with the relevant one for the new type of gas supply. 6 package of the injectors supplied with the appliance. [. . . ] The brown coloured phase cable (fitted in the terminal block contact marked with "L") must always be connected to the network phase. Replacement of the voltage cable Only cable types H05RR-F, H05V2V2-F T90 or H05 BB-F must be used. The cable section must be suitable to the voltage and the working temperature. The yellow/green earth wire must be approximately 2 cm. To open the terminal block and reach the terminals, proceed as follows: l insert the point of a screwdriver into the visible protrunding part of the terminal block; l exert a light pressure and lift (Fig. [. . . ]