User manual AEG-ELECTROLUX 33320DK-M

[. . . ] They must have supervision or instruction for the operation of the appliance by a person who is responsible for their safety. â· Children must get supervision to make sure that they do not play with the appliance. â· Keep all packaging away from children. There is the risk of suffocation or injury. [. . . ] â· When the appliance has a malfunction, a red visual signal flashes on the floor below the appliance door. If the appliance is installed in height, with a flush kitchen furniture door, the visual signal does not show. When the washing programme starts, a red visual signal shows on the floor below To operate with the controls, keep the appliance door ajar. It comes on when it is necessary to fill the salt container. After you fill the container, the salt indicator can stay on for some hours. This does not have an unwanted effect on the operation of the appliance. It comes on when it is necessary to fill the rinse aid dispenser. It comes on when the washing programme is completed. 1) When the salt container and/or the rinse aid dispenser are empty, the related indicators do not come on while a washing programme operates. After ten minutes from the end of the washing programme, the Auto Off function automatically deactivates the appliance. This helps to decrease energy consumption. Turn the cap clockwise to close the salt container. It is correct that water comes out from the salt container when you fill it with salt. If you use the detergent tablets, put the tablet in the detergent dispenser 1 . Press the lid until it locks into position. Use long washing programmes when you use the detergent tablets. These cannot fully dissolve with short washing programmes and can decrease the washing results. Use of rinse aid Rinse aid makes it possible to dry the dishes without streaks and stains. the rinse aid dispenser automatically adds rinse aid during the last rinsing phase. Do these steps to fill the rinse aid dispenser: 1. Fill the rinse aid dispenser 3 with rinse aid. Remove the spilled rinse aid with an absorbent cloth to prevent too much foam during the washing programme. [. . . ] To change the selection while the washing programme operates, it is necessary to cancel the programme. â· Press the Reset button until the display shows two horizontal status bars. Make sure that there is detergent in the detergent dispenser before you start a new washing programme. For better drying results, keep the appliance door ajar for some minutes. [. . . ]