User manual AEG-ELECTROLUX 341 D

[. . . ] Never use the hood without effectively mounted grating. The hood must NEVER be used as a support surface unless specifically indicated. The premises must be sufficiently ventilated, when the kitchen hood is used together with other gas combustion devices or other fuels. The suctioned air must not be conveyed into a conduit used for the disposal of the fumes generated by appliances that combust gases or other fuels. [. . . ] The paper grease filter is very thin (approx. 1 mm) and positioned on the inside of its related support grille. The filter should be changed once a month. The grille should be cleaned with luke warm water and non-abrasive detergent when you change the filter. The grease filter can be ordered from your local Service Force Centre. 3 Removing the filter Remove the stops to take out the filter. Clean the inner housing using a hand hot solution only(never use caustic detergents, abrasive powders or brushes). The charcoal filter should only be used if you want to use the hood in recirculation mode. The charcoal filter cannot be washed nor regenerated. The charcoal filter should be replaced every 4 months under normal use. Replacement filters are available from your local Service Force Centre. Turn the filter clockwise in order to lock the filter into position. Always specify the hood model code number and serial number when ordering replacement filters. This information is shown on the rating plate located on the inside of the unit. The charcoal filter can be ordered from your local Service Force Centre. You are therefore strongly recommended to follow these instructions. The manufacturer declines all responsibility for any damage to the motor or any fire damage linked to inappropriate maintenance or failure to observe the above safety recommendations. Prior to touching the light bulbs ensure they are cooled down. Remove the grille Note: lamps are accessible also by removing the light shield, these are supplied with side lock/unlock plastic spring, grasp it to remove the light shield. Replace the old bulb with a new one of the same type. If the light does not come on, make sure the bulb has been inserted correctly before contacting your local Service Force Centre. Clean the outside of the hood using a damp cloth and a solution of water and mild washing up liquid. [. . . ] Power cable replacement must be undertaken by the authorized service assistance centre or similar qualified person. Do not connect the appliance to the mains until the installation is fully complete. In addition check whether near the installation area of the hood (in the area accessible also with the hood mounted) an electric connection to the mains is available and if it is possible to connect a fumes discharge device to the outside (Extraction mode only). Check that this, once installation is completed, is not obstructed and that there is sufficient space so that the purified fumes and steam can return easily into the kitchen. [. . . ]