User manual AEG-ELECTROLUX 353WK-M

[. . . ] Use this section until you are familiar with your new Hob. The section "Cleaning and Maintenance" provides information on both daily and more thorough cleaning of the individual components of the Hob. Should problems arise when you use the Hob, you can look in the section "Before calling service", where there are instructions on how to remedy some practical and technical problems yourself. Regards, 2 Table of contents Contents For the user Page no Your new appliance . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] Repairs must only be carried out by a qualified/competent person. Contact your local AEG Service Centre. During Use The wok is intended for domestic cooking only. It is not designed for commercial/industrial purposes. Ensure that the control knob is in the OFF position when not in use. Do not use the wok if it is damaged in any way, contact your local AEG Service Centre. Never use plastic or aluminium dishes on the wok. Never leave the wok unattended while deep fat frying, or heating fats and oils. Disposal Make the wok unusable by cutting off the cable. Dispose of any packaging material and old appliances at an authorised disposal site. 4 Description of the product Burner Knob Placement of grid Guide knop for grid 5 Operatings instructions Burner markings Off. flame The operating knob has a ring showing the scale of markings. 6 Burner cover/inner burner ring/outer burner ring Together with the inner burner ring the outer burner ring forms a space where the final mixture of gas and air takes place in order to make the gas burn correctly. Please note: It is consequently very important that the inner burner ring/outer burner ring is placed correctly, together with the cover. If the burner cover/rings are wrongly placed the burner will operate incorrectly, and the burner may be damaged within a short space of time. It is also important, that the inner air ring is placed correctly. Cover Burner ring Ignition electrode (A) The burner has been provided with an ignition electrode. As long as the operating knob is depressed, the automatic ignition will ensure that a spark is emitted between the ignition electrode and the burner cover. Ignition electrode (A) Burner Main nozzle Thermo Sensor (B) The gas unit features fully-secured gas taps (thermo-fuse) In case the flame goes out, the thermo sensor automatically prevents gas admission after a shorter time (Max. Note: Gas admission is always allowed while the operation button is pressed See start-up procedure Thermo Sensor (B) 7 Outer burnerring Cover Inner burnering Air valve Burner body 8 Please note: If the wok is mounted in a table top with a cupboard underneath, the flame might be blown out if the door is slammed. The wok-unit has a special pan support which enables use of a wok pot with curved bottom. When using cooking utensils with a flat bottom the diameter of the utensils must not be less than 26 cm. 9 Ignitions 1. Depress and turn the control knob for the burner, the left to Max. The ignition electrode will emit sparks, and when the mixture of gas and air is correct, the burner will be ignited. Is not possible to connect the unit to mains, a match may be used to ignite the burner 3. After starting the burner, press the control knob for approx. 10 seconds to activate the automatic thermo couple. Important Ignition position is at Max flame 10 Cleaning and maintenance of For reasons of hygiene and safety, the cooking burner must be kept clean. [. . . ] Finally, fit the outer burner ring, taking care that the guide pin engages in the notch. 4 Outer burner ring 16 Gas installation In accordance with local requirements for domestic gas cooking appliances. Gas installation must only be carried out by an authorised person. For gas types see technical data. Gas connection The gas intake is situated at the lower rear of the appliance. [. . . ]