User manual AEG-ELECTROLUX 4115

[. . . ] 2 LCD Display . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 Safety and Maintenance . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 Safety Precautions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 Caring for this Product . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] BATTERIES 2 pieces of UM-4 or "AAA" batteries are supplied with the product. Insert the batteries according to the + and ­ polarities shown. Press RESET. SAFTY AND CARE INSTRUCTIONS SAFTY PRECAUTIONS Please observe the following safety precautions when setting up and using this product. · LCD panel ­ The LCD panel is made of glass and may break if the unit is dropped or impacted. · Heat sources ­ Keep the product away from heat sources such as radiators, stoves, heaters, and other heat-generating products. · Water and moisture ­ Do not use the product in or near water or in high moisture areas such as a bathroom. 3 2/3/05, 11:21 AM RM926(EN4) 3 EN EN ABOUT RADIO RECEPTION The product is designed to automatically synchronize its calendar clock once it is brought within range of the DCF77 radio signal from Frankfurt, Germany (Continental Europe) or MSF-60 from Rugby, England (U. K. ). Pull down the battery compartment cover and slide the EU / UK switch to the appropriate area that you wish the unit to receive the radio signal. After installing the batteries, the full LCD display segment will activate for about 1 second, and then show the clock, date and reception signal indicator. Replace the batteries whenever the low battery icon is displayed, when the LCD is dim or does not illuminate when the power is on. Replace both batteries at the same time ­ it is dangerous to mix old and new batteries. NOTE It is recommended that alkaline batteries be used for this product to improve the functionality of this product and extend battery life. For best reception, place the device away from metal objects and electrical appliances. Other causes for signal interference include electrical transmission towers, steel reinforced construction, and metal siding. Reception is ideal when placed near a window. BACKLIGHT During normal clock display mode, press SNOOZE / LIGHT to enable the unit's backlight. The backlight is turned on for 5 seconds and if any other buttons are pressed during that time, it will remain on before automatically turning off 5 seconds after the last button is pressed. CLOCK AND CALENDAR The upper line of the unit's LCD displays the clock hour / minutes / seconds, AM/PM (for 12-hour display), as well as weekday, time-zone offset and language. The lower line displays the radio reception signal, calendar (datemonth or month-date), and dual alarm 1 and alarm 2 times. 5 RM926(EN4) 5 2/3/05, 11:21 AM EN EN Press MODE to toggle between 3 clock displays: Hour-Minute-Second (local time) Day-Month (of local time) SETTING THE CLOCK AND CALENDAR Before you can manually set the clock and calendar, you must specify the current time-zone you live in and the time format (12- or 24-hour). Press and hold MODE for 2 seconds to enter clock setting mode. The time-zone offset hour digits will blink. The default value of the offset hour is "00". +1), the time displayed will be the radio clock time plus 1 hour. Hour-Minute-Day of the Week (local time) Day-Month (of local time) Hour-Minute-Time zone offset Day-Month (of local time) 2. Press or to adjust the value (press and hold to adjust in fast increments) and press MODE to confirm. [. . . ] The alarm will sound again after 8 minutes. Press and hold SNOOZE/LIGHT for 2 seconds or press ALARM to mute the snooze function. The alarm will automatically be set to sound again at the same time after 24 hours. The snooze function can also be disabled by entering any setting mode, if the second alarm sounds, or pressing . [. . . ]