User manual AEG-ELECTROLUX 502DDB

[. . . ] 10 Safeting warnings for user . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 11 Hood operation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 12 Care and maintenance . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 13 Metal grease filter . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] IMPORTANT The wires of the mains lead supplied with this appliance are coloured in accordance with the following code: Blue-Neutral Brown-Live As the colours of the flexible cord of this appliance may not correspond with the coloured markings identifying the terminals in the plug, proceed as follows: The wire which is coloured brown must be connected to the terminal which is marked with the letter L or coloured red. The wire which is coloured blue must be connected to the terminal which is marked with the letter N or coloured black. Appliances with 2 wires BLUE (NEUTRAL) BROWN (LIVE) LOAD L N LOAD L SUPPLY DP 13A, 250V FUSE ON N SUPPLY 5 Safety warnings for kitchen unit installer When the unit is used in its extractor version, a sufficiently large ventilation hole must be provided, with dimensions that are approximately the same as the outlet hole. The air outlet must not be connected to chimney flues or combustion gas ducts. The air outlet must under no circumstances be connected to ventilation ducts for rooms in which fuel-burning appliances are installed. It is advisable to apply for authorization from the relevant controlling authority when connecting the outlet to an unused chimney flue or combustion gas duct. The air outlet installation must comply with the regulations laid down by the relevant authorities. National and regional building regulations impose a number of restrictions on using hoods and fuel-burning appliances connected to a chimney, such as coal or oil room-heaters and gas fires, in the same room. The local decree on fuel-burning systems specifies a maximum depression of 0. 04 mbar in such rooms. Hoods can only be used safely with appliances connected to a chimney if the room and/or flat (air/environment combination) is ventilated from outside using a suitable ventilation hole approximately 500-600 cm2 large to avoid the possibility of negative pressure being created during operation of the hood. If you have any doubts, contact the relevant controlling authority or building inspector's office. Since the rule for rooms with out fuel burning appliances is "air inlet should be same size as extractor outlet hole", an aperture of 500-600 cm2, which is to say a larger hole, could reduce the performance of the extractor hood. If the hood is used in its filtering version (carbon filter), it will operate simply and safely in the above conditions without the need for any of the aforementioned measures. When the hood is used in its extractor function, the following rules must be followed to obtain optimal operation: -- short and straight outlet hose -- minimum number of bends in the outlet hose -- Install hoses with an acute angle, always following a gentle curve only -- hose as large as possible (100 mm Ø). Failure to observe these basic rules will drastically reduce the performance and increase the noise levels of the extractor hood. 6 When used as an extractor unit, the hood must be fitted with a 100mm diameter hose. If the fumes must be forced out through the wall, you must obtain a MKZ sizable wall exhaust pipe (with external exhaust and air intake), E-Nr. - 610 899 004 (Ø 120 mm) which is one of our optional parts. When installing the hood, make sure you respect the following minimum distance from the top edge of the cooking hob/ ring surfaces: electric cookers gas cookers coal and oil cookers 650 mm 700 mm 900 mm min. Where flexible ducting is fitted the length should be no more than: -- 3 metres with one 90° bend -- 2 metres with two 90° bends. Bends of more than 90° will reduce the efficiency of the hood and reduce the air flow. General details The hood is supplied as a ducted version, but may also be used in recirculation mode by inserting a charcoal filter (Special accessories). The air is ducted out through a pipe which is connected to the outlet hole A (fig. To connect the hood to a wall box, you use hoses and wall boxes as offered on the AEG price list as optional extras. [. . . ] Soak metal filter cassette for about one hour in hot water with a greaseloosening cleaner, then rinse off thoroughly with hot water. Place metal filter cassette in dishwasher. Select most powerful washing program and highest temperature, at least 65° C. When washing the metal grease filter in the dishwasher a slight discoloration of the filter can occur. [. . . ]