User manual AEG-ELECTROLUX 5051B-W

[. . . ] Com Register your product for better service: www. Com/productregistration Buy Accessories, Consumables and Original spare parts for your appliance: www. We recommend the use of original spare parts. When contacting Service, ensure that you have the following data available. [. . . ] Adequate air circulation should be around the appliance, lacking this leads to overheating. to achieve sufficient ventilation follow the instructions relevant to installation. Wherever possible the back of the product should be against a wall to avoid touching or catching warm parts (compressor, condenser) to prevent possible burn. The appliance must not be located close to radiators or cookers. Make sure that the mains plug is accessible after the installation of the appliance. Any electrical work required to do the servicing of the appliance should be carried out by a qualified electrician or competent person. â· This product must be serviced by an authorized Service Centre, and only genuine spare parts must be used. Before maintenance, switch off the appliance and disconnect the mains plug from the mains socket. â· Do not clean the appliance with metal objects. This appliance does not contain gasses which could damage the ozone layer, in either its refrigerant circuit or insulation materials. The appliance shall not be discarded together with the urban refuse and rubbish. Milk bottles: these should have a cap and should be stored in the bottle rack on the door. Bananas, potatoes, onions and garlic, if not packed, must not be kept in the refrigerator. Do not open the door frequently or leave it open longer than absolutely necessary. â· If the ambient temperature is high and the Temperature Regulator is set to low temperature and the appliance is fully loaded, the compressor may run continuously, causing frost or ice on the evaporator. If this happens, set the Temperature Regulator toward warmer settings to allow automatic defrosting and so a saving in electricity consumption. Unplug the appliance before carrying out any maintenance operation. This appliance contains hydrocarbons in its cooling unit; maintenance and recharging must therefore only be carried out by authorized technicians. Clean the inside and accessories with lukewarm water and some neutral soap. â· Regularly check the door seals and wipe clean to ensure they are clean and free from debris. Do not pull, move or damage any pipes and/or cables inside the cabinet. Never use detergents, abrasive powders, highly perfumed cleaning products or wax polishes to clean the interior as this will damage the surface and leave a strong odour. [. . . ] Do not keep the door open longer than necessary. Decrease to room temperature before storage. Make sure that products do not touch the rear plate. The melting water outlet Attach the melting water does not flow in the evapo- outlet to the evaporative rative tray above the com- tray. [. . . ]