User manual AEG-ELECTROLUX 505E-S

[. . . ] You've chosen a product that brings with it decades of professional experience and innovation. Ingenious and stylish, it has been designed with you in mind. So whenever you use it, you can be safe in the knowledge that you'll get great results every time. Visit our website for: Get usage advice, brochures, trouble shooter, service information: www. electrolux. com Register your product for better service: www. electrolux. com/productregistration Buy Accessories, Consumables and Original spare parts for your appliance: www. electrolux. com/shop CUSTOMER CARE AND SERVICE We recommend the use of original spare parts. [. . . ] and the time setting flash in the display. Touch a sensor field to stop the acoustic signal. Deactivate the appliance. Touch . and "00" flash in the display. First you set the seconds and then minutes and hours. Touch and at the same time to reset the set time. Touch or the MINUTE MINDER starts automatically after five seconds. When set time ends, an acoustic signal sounds for two minutes. "00:00" and flash in the display. 3. 5. 7. 14 www. electrolux. com 6. Touch a sensor field to stop the acoustic signal. SETTING THE TIME DELAY FUNCTION DURATION and END can be used at the same time, if the appliance is to be switched on and off automatically later. In and then case first set the DURATION function (refer to "Setting the DUEND RATION" and "Setting the END "). ENGLISH 15 AUTOMATIC PROGRAMMES WARNING!Refer to "Safety information" chapter. The display shows: cooking time, duration symbol , a default weight, a unit of measurement (kg, g). 16 www. electrolux. com USING THE ACCESSORIES WARNING!Refer to "Safety information" chapter. 5. Touch or the settings save automatically after 5 seconds. You can set the core temperature only when flashes. If is in the display but does not flash before you set the core temperature, touch and or to set a new value. Set the heating function and, if necessary, the oven temperature. The display shows the current core temperature and , which shows the relation between the set oven temperature and the current oven temperature. The core temperature sensor must stay in the meat and in the socket during the cooking. While the appliance calculates the approximate duration time, the value of the Count Up Timer function shows in the Timer / Residual heat display. When the first calculation ends, the Timer/Residual heat display shows - and then the approximate duration of the cooking. The appliance continues to calculate the duration during the cooking. The display updates at intervals with the new duration value. [. . . ] If there is no socket supply line, the electrical installation must have an isolation device which lets you disconnect the appliance from the power supply. The isolation 400V 3~ 400V device must have a contact opening width of minimum 3 mm (in reference to NIN SEV 1000). The customer must have a socket for the electrical connection that is accessible and outside the coordination room. The length of the connection cable must be approximately 120 cm with lines connected directly to the power supply. [. . . ]