User manual AEG-ELECTROLUX 5311B-W

[. . . ] cHILDREN AND VULNERABLE PERSONS SAFETY · Do not let persons, children included, with reduced physical sensory, reduced mental functions or lack of experience and knowledge to use the appliance. They must have supervision or instruction for the operation of the appliance by a person who is responsible for their safety. Children must get supervision to make sure that they do not play with the appliance. Keep all packaging away from children. [. . . ] DELAY START BUTTON Press this button again and again to delay the start of the washing programme from 1 to 19 hours. SETTING MODE The appliance must be in setting mode for these operations: · ­ It is necessary to cancel the programme or the delay start to go back to the setting mode. Be sure that the set level of the water softener agrees with the water hardness in your area. Fill the salt container with dishwasher salt. Fill the rinse aid dispenser with rinse aid. Load cutlery and dishes into the appliance. Set the correct washing programme for the type of load and soil. Fill the detergent dispenser with the correct quantity of detergent. If you use the combi detergent tablets ('3 in 1', '4 in 1', '5 in 1'), use the multi- These minerals and salts can cause damage to the appliance. Adjust the level of the water softener if this does not agree with the water hardness in your area. Contact your local water authority to know the water hardness in your area. Fill the rinse aid dispenser 4 with rinse aid. Remove the spilled rinse aid with an absorbent cloth to prevent too much foam during the washing programme. Press the lid until it locks into position. You can set the rinse aid dosage between position 1 (lowest dosage) and position 6 (highest dosage). Some types of tablets can contain other agents. Do a check if these tablets are applicable for the local water hardness. refer to the instructions from the manufacturer. When you set the multitab function, it stays on until you deactivate it. The programme duration can increase if you use the multitab function. activate the multitab function before the start of a washing programme. You cannot activate the multitab function when the programme operates. [. . . ] TO CLEAN THE EXTERNAL SURFACES Clean the external surfaces of the appliance and control panel with a moist soft cloth. Put the flat filter (C) to its initial position. Make sure that it assembles correctly under the two guides (D). Put the coarse filter (A) in the microfilter (B) and push the filters together. [. . . ]