User manual AEG-ELECTROLUX 5708D-M/AUS

[. . . ] Failure to do so could cause grease deposits to build up, resulting in a fire hazard. For the installer · When used as an extractor unit, the hood must be fitted with a 120mm diameter hose. · When installing the hood, make sure you respect the following minimum distance from the top edge of the cooking hob/ring surfaces: electric cookers 650 mm gas cookers 750 mm coal and oil cookers 800 mm min. · The national standard on fuel-burning systems specifies a maximum depression of 0. 04 bar in such rooms. · The air outlet must not be connected to chimney flues or combustion gas ducts. [. . . ] Refit the grease filters when they are dry. When washing the metal grease filter in the dishwasher a slight discolouration of the filter can occur, this does not have any impact on its performance. · Clean the inner housing using a hot detergent solution only (never use caustic detergents, abrasive powders or brushes). 8 Charcoal filter · The charcoal filter should only be used if you want to use the hood in the recirculation function. · To do this you will need an original AEG charcoal filter (available from your local Service Force Centre). · The charcoal filter cannot be washed nor regenerated. The charcoal filter should be replaced every 12 months under normal use. Replacement filters are available from your local Service Force Centre. · Fitting Remove the grease filter. Fit the charcoal filter on the lamp side, press in both red lugs on the charcoal filter, and unclip the charcoal filter forwards (towards the front edge of the appliance). Refit the grease filter. · To remove proceed in the reverse order. · Always specify the hood model code number and serial number when ordering replacement filters. This information is shown on the registration plate located on the inside of the unit. · The charcoal filter can be ordered from your local AEG Service Force Centre. Fig. 5 9 Warning · Failure to observe the instructions on cleaning the unit and changing the filters will cause a fire hazard. You are therefore strongly recommended to follow these instructions. · The manufacturer declines all responsibility for any damage to the motor or any fire damage linked to inappropriate maintenance or failure to observe the above safety recommendations. Changing the light bulb · Disconnect the cooker hood from the main supply. · Unlock the lamp cover by twisting the bolts to the left and fold down the bulb cover. · Replace the old bulb with a new one of the same type. · Close the bulb cover and relock it by twisting the bolts to the right. · If the light does not come on, make sure the bulb has been inserted correctly before contacting your local Service Force Centre. Fig. 6 10 What to do if If your appliance fails to work properly please carry out the following checks. Symptom The cooker hood will not start. . . [. . . ] Loosen two screws and pull the control unit forwards out of the housing. Caution: The socket connection cable is only long enough for a maximum distance of 40 cm! Fig. Open the cable channel on the top side of the housing and pull the wire for the control unit through the opening. Shut the cover so that it supports the wire. [. . . ]