User manual AEG-ELECTROLUX 61000M-WR

[. . . ] To connect the heating elements it is necessary to turn the relative knob clockwise or anticlockwise. Indicator light 6 shows the connection of one or more heating elements. How to use the cooking zones Heating takes place only in the inside part of the circles drawn on the special glass. The circles have to be completely covered by the pots. 61040 K MODEL 61040 K MODEL 31050 K MODEL FIG. [. . . ] - Do not slide the pot on the glass as it can damage the glass. - Do not scrape the pot against the glass so to not damage it. - During the use of the cooking zones, please, keep children away from the hot plates. Make sure that the handles of the pots are facing towards the interior. Be aware that overheated fats and oils may become flammable. Cooking zones after using remain warm; don't place your hands or objects on the glass to avoid burns, till the indicator light is off. If the glass cracks, please, disconnect the appliance. Don't use plastic pots or aluminum sheets. Don't use hob as a supplementary surface. FIG. 4 5 CLEANING 2) ELECTRIC HOB To protect the surface and maintain the clean and bright finish, use a silicone conditioner. This will Protect the surface whilst cooking. The rear wall, adjacent and surrounding surfaces must therefore be able to withstand temperatures above 65° C. 4) FIXING A special sealing strip underneath the hob must be used. Make sure it is correctly positioned with no gaps to avoid any water infiltration. To fit the strip in the right way, please, respect the following instructions: - Fix the hooks in the relative accomodations of the body. - Turn the hob over, take the seal strips off from their support, taking care that the transparent protection remains attached to the seal. Correctly place the seal "E" (fig. 11) under the hob edge, so that the external side of the seal fits together COMPLY WITH THE DIMENSIONS (mm) A 2 ELEM. 285 560 B 485 490 C 57. 5 57. 5 D E 57. 5 100 min. 12 7 INSTALLATION 5) ELECTRICAL CONNECTION The electrical connection must be done in accordance with all electrical and installation requirements of the Regulation. Before proceeding with the connection, please, verify that: - The power of the electrical system and the power of the outlets is adequate to the maximum power of the appliance (see the identification label in the lower part of the body). - The electrical system must be earthed according to the Regulations. We disclaim all responsabilities for not observing such points. [. . . ] - In an alternative solution the electrical connection can also be protected by a differential switch with high sensitivity. We recommend to fix the earth coloured cable to an appropriate earth installation. WARNINGS: All our products are projected and built according to the European Norms EN 60 335-1 and EN 60 335-2-6 and relative amendments. The appliance has been produced according with the European Directives: - CEE 89/336 + 92/31 + 93/68 concerning the compatibility electromagnetic. - CEE 73/23 + 93/68 concerning the electrical security. - The input cable has to be located so that it never reaches a temperature over 75° C. 4 HEATING ELEMENTS 2 HEATING ELEMENTS FIG. [. . . ]