User manual AEG-ELECTROLUX 61370M-MNAF4

[. . . ] C61370M Glaskeramik-Kochfeld Glaskeramikhäll Keraaminen keittotaso Glass Ceramic Cooking Surface Âñòðàèâàåìàÿ âàðî÷íàÿ ïîâåðõíîñòü Gebrauchsanweisung/Montageanweisung Bruksanvisning/Installationsanvisning Käyttöohje/Asennusohje Operating Instructions/ Installation Instructions Èíñòðóêöèÿ ïî ýêñïëóàòàöèè è ìîíòàæó Dear Customer, Please read these operating instructions through carefully. Above all, please take note of the "Safety" section on the first few pages. Please keep these operating instructions for future reference. Pass them on to any subsequent owner of the appliance. [. . . ] Remove the film from the digital display panel. 2. Wipe the ceramic glass cooking surface with a damp cloth to remove any traces left from manufacturing. 1 Important: Do not use any caustic, abrasive cleaners!The surface could be damaged. Using the Cooking Zones 3 3 When the cooking zones are switched on, they may hum briefly. This is a characteristic of all ceramic glass cooking zones and does not impair either the function or the life of the appliance. The cooking zones are operated using the ring switches on the cooker or switch box as described in the relevant set of instructions. 59 Operating Instructions Digital Displays The current operating state of the relevant cooking zone can be read off in the digital displays. 1. 9 = heat setting 1 = lowest heat setting 9 = highest heat setting % = intermediate stage (= 6. 5) 3 14 heat settings (including intermediate settings) can be set in the ranges 1 - 9. You can select intermediate settings in the ranges 2 - 7. A = Automatic Heating-Up The cooking zone is set to automatic heating-up. 3 A is lit until the automatic feature switches over to the set further cooking stage. H = Residual Heat Indication 1 3 2 Danger!The display goes out after the cooking zone cools down. H is only displayed when the cooking zone is switched off. You can use the residual heat for melting and keeping food warm. 60 Operating Instructions Switching On the Triple Ring Cooking Zone Depending on the size of the pan, on the triple ring zone the two larger rings can be switched on, in addition to the smallest cooking zone, using the appropriate touch switch on the glass ceramic cooking surface. Switch on cooking zone in the normal way using the ring switch. ­ The smallest ring on the cooking zone is switched on. Tap the corresponding touch switch on the cooking surface once. ­ The larger ring is also switched on. To switch on the largest ring, tap the touch switch again. To switch off the larger ring, tap the touch switch again. If the triple ring cooking zone is switched off completely using the ring switch, the larger rings must be switched on again the next time the ring is switched on, if required. Switching on the Casserole Zone Depending on the size of the pan, on the casserole zone the larger ring can be switched on, in addition to the smaller cooking zone, using the touch switch on the glass ceramic cooking surface. Switch on cooking zone in the normal way using the ring switch. Tap the corresponding touch switch on the cooking surface. ­ The larger ring is also switched on. To switch off the larger ring, tap the touch switch again. If the casserole zone is completely switched off using the ring switch, the larger ring must be switched on again, if needed, the next time the zone is switched on. [. . . ] · In respect of fire protection, this appliance corresponds to type Y (IEC 335-2-6). Only this type of appliance may be installed with a high cupboard or wall on one side. · It is not permitted to fit drawers below the cooking surface. · Protection against electric shock must be provided by the installation. [. . . ]